Abstract:In this study, the crystal plasticity finite element method was established by coupling the crystal plasticity and finite element method (FEM). The effect of rolling deformation and slip system of polycrystalline Al-Mg-Si aluminum alloy was investigated. The results showed that there was a pronounced heterogeneity in the stress and strain distribution of the material during cold rolling. The maximum strain and shear strain occurred at surface of the material. The smaller the grain size, the lower the strain concentration at the grain boundary. Meanwhile, a smaller strain difference existed between the grain interior and near the boundary. The rotation of grains leads to significant differences in deformation and rotation depending on their initial orientations during the rolling process. The slip system of (11-1)<-110> had a large effect on the plastic deformation, (111)<10-1> is second, and the effect of (1-11)<011> slip system on the plastic deformation is the smallest. After deformation, the grain orientation concentration was increased with deformation. Therefore, both the strength and volume fraction of texture were increased with the increase in rolling deformation. The experimental results of EBSD indicated that the large rolling reduction resulted in severe grain twisting, so the texture strength was increased. The simulation results were in close agreement with the experimental results. This study provides a theoretical basis for the rolling process, microstructure, and performance control of aluminum alloys.

Correlation Between Microstrain and Crystallite Size in Alumina

Formation of Nanocrystalline Fcc Phase by Mechanically Driven Crystallization

Effect of CeO_2 and ZrO_2 Additives on Microstructure and Thermal Stability of High-Energy Ball Milling Al_2O_3 Powder

Molecular Dynamics Study of Substrate Temperature and Incident Energy Influence on the Crystallization Behavior of Alumina Thin Film Deposition Process

Microstructural Evolution and Microhardness Change of Al–7wt%Si–0.3wt%Mg Alloy Granules/powder Particles During High Energy Ball Milling

Microstructural Evolution of Fe-Based Metallic Glass/2024-Al Powder During High Energy Ball Milling Process

Influence of Parameters of High-Energy Ball Milling on the Synthesis and Densification of Magnesium Aluminate Spinel

Microstructural Evolution During High Energy Ball Milling of Fe2o3-Sio2 Powders

In-situ Study of Microstructural Evolution and Local Strain Distribution During Tensile Loading of Near-Micrometre Grain Size Aluminium

On Advancemeat of Carbothermal Reduction of Alumina by High Energy Ball Milling

Crystal Plasticity Finite Element Simulation of Grain Evolution Behavior in Aluminum Alloy Rolling

A comparative study of the influence of milling media on the structural and microstructural changes in monoclinic ZrO2

Effect of ball milling treatment on the microstructures and properties of Cr2AlC powders and hot pressed bulk ceramics

EFFECTS OF BALL-MILLING INTENSITY ON STRUCTURAL-CHANGES IN MIXED 50NI-50TI POWDERS DURING MECHANICAL ALLOYING PROCESS

The amorphization of crystalline silicon by ball milling

Preparation of SrAl2O4 from an oxide mixture via a high-energy ball milling

The microstructure of ball milled nanocrystalline vanadium; variation of the crystal imperfection and the lattice parameter

Microstructure Evolution of A Fine Grain Al-50wt%Si Alloy Fabricated by High Energy Milling

Effects of balll11illing intensity on structural changes in mixed 50Ni-50Ti pO\Nders during l11echanicalalloying process

Phase Transformation and Gas–solid Reaction of Al2O3 During High-Energy Ball Milling in N2 Atmosphere

Superstructure in nano-crystalline Al50Cu28Fe22 alloy