Multi-objective optimization investigation on wave plate separator by using Taguchi method
Pengfei Wang,Xinxin Zhang,Xiangyu Luo,Jin Huang,Haihang Liu,Wensheng Zhao
DOI: https://doi.org/10.1016/j.seppur.2024.126704
IF: 8.6
2024-07-01
Separation and Purification Technology
Abstract:To collect the liquid droplets from the gas perfectly, a series of 3D optimal studies on the performance of one type of novel wave plate separator are conducted to reduce the pressure lost and enhance the separation efficiency. The computational fluid dynamic (CFD) method to predict and visualize the 3D two-phase fluid field inside the wave plate separator based on preliminary baffle design purpose is conducted and verified with the previous and present experimental data. The set of design parameters is identified for the structure of the separator and the Taguchi method is employed to determine the 25 candidate designs for optimum, the Minitab software is applied in the regression analysis. It is found that increasing plate spacing leads to a decrease in friction factor and separation efficiency. But narrow, it will lead to a sharp increase in the friction factor and droplet re-entrainment. Most structural design methods to improve separation efficiency will result in a large friction factor, to reduce the friction factor, the optimal plate configuration is: Plate distance 35.5 mm, vane depth 4 mm, wavelength 80 mm, vane length 10 mm, plate angle 150°, fillet radius between plates and vanes 3 mm, plate distance, Fillet radius between plates and vanes, and vane depth have a significant impact on the signal-to-noise ratio of separation efficiency, and the optimal structure parameter configuration is plate distance 25 mm, vane depth 10 mm, wavelength 80 mm, vane length 10 mm, wave angle 90°, fillet radius between plates and vanes 6 mm. The results of the multivariate linear fitting equation of the friction coefficient have good predictability, with a correlation of more than 80 %.
engineering, chemical