Abstract:Axial piston pump with pre-compression volume(PCV) has lower flow ripple in large scale of operating condition than the traditional one. However, there is lack of precise simulation model of the axial piston pump with PCV, so the parameters of PCV are difficult to be determined. A finite element simulation model for piston pump with PCV is built by considering the piston movement, the fluid characteristic(including fluid compressibility and viscosity) and the leakage flow rate. Then a test of the pump flow ripple called the secondary source method is implemented to validate the simulation model. Thirdly, by comparing results among the simulation results, test results and results from other publications at the same operating condition, the simulation model is validated and used in optimizing the axial piston pump with PCV. According to the pump flow ripples obtained by the simulation model with different PCV parameters, the flow ripple is the smallest when the PCV angle is 13°, the PCV volume is 1.3×10−4 m3 at such operating condition that the pump suction pressure is 2 MPa, the pump delivery pressure 15 MPa, the pump speed 1 000 r/min, the swash plate angle 13°. At the same time, the flow ripple can be reduced when the pump suction pressure is 2 MPa, the pump delivery pressure is 5 MPa,15 MPa, 22 MPa, pump speed is 400 r/min, 1 000 r/min, 1 500 r/min, the swash plate angle is 11°, 13°, 15° and 17°, respectively. The finite element simulation model proposed provides a method for optimizing the PCV structure and guiding for designing a quieter axial piston pump.

Impacts of the Split Conjugated Pistons in Conjugated Cylinders of a Multiple Stage Reciprocating Compressor in Start Duration

Impact of the Piston Secondary Motion on Its Slap Force

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Study of the Pressure Distribution Between the Piston Rings in Reciprocating Compressors

Pre-Compression Volume on Flow Ripple Reduction of a Piston Pump

Experimental investigation of pressure distribution between the piston rings and its formation in reciprocating compressors

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Experimental Study on the Influence of the Rotating Cylinder Block and Pistons on Churning Losses in Axial Piston Pumps

Performance Simulation Analysis of a Novel Dual-piston Two-Stage Carbon Dioxide Linear Compressor

Experimental Investigation on the Steady-State Performance and Piston Stroke Length Control of A Variable Displacement Wobble Plate Compressor

Operational optimisation of a novel dual-piston linear compressor: Simulation and experiment

Experiment and Analysis of Starting Process of Multistage High Pressure Reciprocating Compressor

Investigation of Flow Behaviour and Heat Rejection for an Air-Cooled Small Multi-Stage Swash-Plate Compressor

Investigation of clearance leakage and piston offset of Joule-Thomson linear compressors at high pressure ratios

Modeling and Performance Analysis of Rotary Compressor Considering Multi-Body Coupling and Bearing Deformation

Theoretical Model Development and Mixed Lubrication Analyses of Rolling Piston Type Rotary Compressors: A Review

Fracture Mechanism and Fault Evolution of Piston Rod in Hydrogen Reciprocating Compressor

Design and Verification Test of the Primary and Secondary Stage Compression Gap Size of Miniature High Pressure Air Compressor

Theoretical Study of the Dynamic Characteristics of a Self-Commutating Liquid Piston Hydrogen Compressor

Theoretical and Experimental Investigations on the Piston Offset Characteristics in a Four-Stage DC Linear Compressor Unit for a 1.8 K Hybrid Cryocooler

Piston offset inhibition method based on check valve backflow in a linear compressor