Abstract:Spout-fluid beds are widely used in the process industry due to their facilitation of an efficient contact between particles and gas. In this paper, a two-fluid model (TFM) is set up to reproduce the various flow structures encountered during spout-fluid bed operation. The effects of normal restitution model and gas-solid drag model are assessed by comparing simulation results with the experimental and discrete particle modeling (DPM) data of Link et al. [Link et al. Chem. Eng. Sci. 2005, 60, 3425-3442; Link et al. AIChE J. 2008, 54, 1189-1202.]. Simulation results show that application of an effective restitution coefficient in TFM can improve the accuracy of prediction significantly. The drag model of HKL predicts a more reasonable result than models of Huilin-Gidaspow, BVK, and Syamlal and O'Brien. Analysis on relative contributions of kinetic motion, friction, and collision to particle-particle momentum transfer parameters, namely, particle pressure and viscosity, shows that particle-particle momentum transfer in the spout and fountain regions is dominated by kinetic motion and that in the annulus region is dominated by friction. A transition region between spout and annulus regions is proposed. This region can be delineated using a single parameter of dimensionless collisional particle pressure because in this region, particle pressure is dominated by the collisional contribution. With an increasing spout-fluid ratio, the stable spout-annulus-fountain structure gradually shifts to an unstable bubble-slug structure. The effect of collision increases and extends to the entire bed. Meanwhile, the effects of kinetic motion and friction decrease. When slugs are formed, a rebound in the influence of friction is observed, accompanied by a decrease in the influence of collision.

Modeling of characteristics of particle residence time in continuous spout-fluid bed with draft tube

Modeling of dense particle flow in the annulus of spouted beds with draft tube

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Investigation of Particle Flow Behaviors in a Simplified Downcomer of Multistage Fluidized Bed

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

Numerical Simulation of Two-Dimensional Spouted Bed with Draft Plates by Discrete Element Method

Discrete Element Simulation of the Hydrodynamics in A 3d Spouted Bed: Influence of Tube Configuration

Numerical Investigation of the Gas‐Solid Flow Characteristics in a Three‐Dimensional Spouted Bed with a Draft Tube

Numerical Investigation of the Time-Related Properties of Solid Phase in a 3-D Spout-Fluid Bed

Two-Fluid Model Simulations of the National Energy Technology Laboratory Bubbling Fluidized Bed Challenge Problem

Two-Fluid Simulation of a Three-Dimensional Spout-Fluid Bed: Flow Structures, Regimes, and Insight into the Mechanism of Particle–Particle Momentum Transfer

Particle dispersion and circulation patterns in a 3D spouted bed with or without draft tube

Effect of Bed Thickness on a Pseudo 2D Gas-Solid Fluidized Bed Turbulent Flow Structures and Dynamics

Hydrodynamics and Heat Transfer in a Fluidized Bed with Liquid Spray: Particle Color-Change Based Measurement and Modelling

DEM Simulation of the Behavior of Particles in a Spout-Fluid Bed with Immersed Tubes

Hydrodynamics of Sawdust in a Spout-Fluid Bed with Draft Tube

Hydrodynamics of a Spouted Bed with Draft Tube

Effects of Draft Tubes on Particle Velocity Profiles in Spouted Beds

Three-Dimensional Modeling of Gas–Solid Motion in a Slot-Rectangular Spouted Bed with the Parallel Framework of the Computational Fluid Dynamics–Discrete Element Method Coupling Approach

Comparison of Two-Fluid and Discrete Particle Modeling of Gas-Particle Flows in Micro Fluidized Beds

Model and Experimental Study of Relationship Between Solid Fraction and Back-Mixing in a Fluidized Bed