Abstract:<p>The damage mechanisms and load redistribution taking place under high temperature (350°C), high cycle fatigue (HCF) of TC17 titanium alloy/unidirectional SiC fibre composites have been investigated <em>in situ</em> using synchrotron X-ray computed tomography (CT) and X-ray diffraction (XRD) under two stress amplitudes. The three-dimensional morphology of the fatigue crack and fibre fractures has been mapped by CT. At low stress amplitude, stable growth occurs with matrix cracking deflecting by 50-100 µm in height as it bypasses the bridging fibres. At higher stress amplitude, loading to the peak stress led to a burst of fibre fractures giving rise to rapid crack growth. Many of the fibre fractures occurred 50-300 µm above/below the matrix crack plane during rapid growth, contrary to that in the stable growth stage, leading to extensive fibre pull-out on the fracture surface. The changes in fibre loading, interfacial stress, and the extent of fibre-matrix debonding in the vicinity of the crack have been mapped over the fatigue cycle and after the rapid growth by XRD. The fibre/matrix interfacial sliding extends up to 600 µm (in the stable-growth zone) or 700 µm (in the rapid-growth zone) either side of the crack plane. The direction of interfacial shear stress reverses over the loading cycle, with the maximum frictional sliding stress reaching ∼55 MPa in both regimes. In accordance with previous studies, it is possible that a degradation in fibre strength at elevated temperature is responsible for bursts of fibre fracture and rapid crack growth under higher stress amplitude.</p>

Effect of temperature on dynamic fatigue behaviour of Si3N4 material

The Dynamic Fatigue Behavior of Si3N4 at Different Temperatures

The Dynamic Fatigue Behavior of Si<sub>3</sub>N<sub>4</sub> at Different Temperatures

Effect of cyclic straining at elevated-temperature on static mechanical properties, microstructures and fracture behavior of nickel-based superalloy GH4145/SQ

Dynamic fatigue behavior of Si3N4-based ceramic tool materials at ambient and high temperatures

Influence Of Loading Method On Fatigue Behaviour Of Si3n4 Ceramics

The effect of the microstructure on the static fatigue behaviour of Si3N4

Influence of Strain Amplitude on Low-Cycle Fatigue Behaviors of a Fourth-Generation Ni-Based Single-Crystal Superalloy at 980 °C

Static fatigue and cyclic fatigue behaviour of Si3N4 ceramics in different environment medias

Extreme Strain Rate and Temperature Dependence of the Mechanical Properties of Nano Silicon Nitride Thin Layers in a Basal Plane under Tension: a Molecular Dynamics Study

Temperature effect on the low cycle fatigue behavior of a directionally solidified nickel-base superalloy

High-temperature Fatigue Behavior in Pre-Cracked Silicon Nitride Composites Doped with Ytterbium Oxide

Effect of Temperature on High‐cycle Fatigue and Very High Cycle Fatigue Behaviours of a Low‐strength Cr–Ni–Mo–V Steel Welded Joint

A comparative study of low cycle fatigue behavior and microstructure of Cr-based steel at room and high temperatures

Molecular dynamics simulation of the temperature effect on ideal mechanical properties of SiC/BN interface for SiCf/SiC composites

Effect of crystal orientation and temperature on the mechanical properties and fracture mechanism of silicon carbide nanowires

Damage accumulation during high temperature fatigue of Ti/SiCf metal matrix composites under different stress amplitudes

High fatigue performance and microscopic mechanisms of in-situ TiB 2 /7050Al composite at different temperatures

Fatigue and fracture behavior of an aluminum-lithium alloy 8090-T6 at ambient and cryogenic temperature

Temperature-dependent Fracture Strength and the Effect of Oxidation for ZrB2-SiC Ceramics

High-temperature tensile behavior of 3D SiC/SiC composites