Abstract:Low-cycle fatigue (LCF) behavior of nickel-based precipitation-strengthened superalloy GH4145/SQ was investigated systematically under fully reversed total strain amplitude control conditions at 538°C in laboratory air. It was shown that the alloy exhibited a pronounced initial fatigue hardening followed by continuous fatigue softening to failure at high strain amplitudes, while at low strain amplitudes the initial hardening was followed by a well-defined saturation stage. Microstructure observations using optical and transmission-electron microscopy revealed that slip band density increased with increasing total strain amplitudes and the size of the γ′precipitates tended to reduction due to repeated shearing by the dislocations with continuous cyclic straining. The above changes in microstructures during cycling were essentially responsible for the fatigue hardening–softening behavior of the alloy. Both optical and SEM micrographs indicated that at low strain amplitudes crack propagation was basically transgranular, while at high strain amplitudes crack propagation was essentially intergranular. Bilinear behavior with a change of slope at a plastic strain amplitude of about 0.2pct was observed in cyclic stress–strain (CSS), Coffin–Manson (C–M) and plastic strain energy–life plots. A change in the number of operating slip systems and the fracture modes with the strain amplitude employed was used to explain this two-slope characteristic. In both the companion specimens test (CST) and the incremental step test (IST) methods the alloy exhibited non-masing type behavior. It was suggested that, for the first approximation, the half-life plastic strain energy could be calculated directly according to the equation without reckoning in the non-masing behavior.

Analysis of fatigue fracture with cyclic overloading for A537 steel in 3.5%NaCl solution at an applied cathodic potential

A Modified Coffin-Manson Model for Ultra-Low Cycle Fatigue Fracture of Structural Steels Considering the Effect of Stress Triaxiality

Investigation on corrosion fatigue properties of TA15 alloy in 3.5%NaCl salt spray

Low cycle fatigue behavior of nickel-based superalloy GH4145/SQ at elevated temperature

Crack Growth Retardation of Single Overload for A537 Steel in a 3.5% NaCl Solution under Cathodic Potential and Free Corrosion Condition

Effect of overload occurence frequency on fatigue crack growth rate of steel A537

STUDY OF FATIGUE CRACK GROWTH RETARDATION, CRACK TIP DEFORMATION AND CRACK CLOSURE UNDER SINGLE OVERLOAD APPLICATION FOR A537 STEEL

A Novel Method for Characterizing the Fatigue Crack Propagation of Steel Via the Weak Magnetic Effect

Effect of Hydrogen on Plastic Deformation Near Crack-tip of A537 Steel in 3.5%nacl Solution

STUDY OF INTERACTION BETWEEN LOADS DURING CORROSION FATIGUE

Experimental study on fatigue crack growth behavior and fracture toughness of SA508-III steel for nuclear reactor pressure vessel

Effects of Applied Potential on the Fatigue Behavior of Alloy 600 in Sodium Chloride Solution

Experimental research on the fatigue crack growth behaviour of Q420C

Investigation of low cycle fatigue crack propagation behavior of 316H steel at 550°C based on cyclic response and damage accumulation: experiment and modelling

Extremely - low cycle fatigue fracture of Q235 steel at different stress triaxialities

In-situ observation of strain evolution and ratchetting of growing fatigue cracks

Application of a Cohesive Zone Model for Simulating Fatigue Crack Growth from Moderate to High <mml:math xmlns:mml="http://www.w3.org/1998/Math/MathML" id="M1"><mml:mi mathvariant="normal">Δ</mml:mi><mml:mi>K</mml:mi></mml:math> Levels of Inconel 718

Experimental studies on crack propagation and accumulative mean strain of cracked stiffened plates under low-cycle fatigue loads

Mixed-mode I&II fatigue crack growth behaviors of 16MND5 steel: The role of crack driving forces and crack closure

An analysis of fatigue crack features at various crack lengths through mating fracture surface pairs

Environment-Assisted Fatigue Crack Growth Along A1-6061/Epoxy Interface