Abstract:The paper presents a novel method for the flotation separation of Cu2+ using microcrystalline adsorption system loaded with CuI prior to the determination by spectrophotometry. The effects of different parameters,such as the dosages of KI, ascorbic acid and octadecyl trimethyl ammonium bromide (OTMAB),various salts and acidity etc. on the flotation yield of Cu2+ have been investigated. The possible flotation separation mechanism of Cu2+ was discussed.The results showed that under the optimum conditions,octadecyl trimethyl ammonium bromide cation (OTMAB+) reacted with I- to produce the microcrystalline matter (Ms-M) of (OTMAB+·I-), Cu2+ could be reduced to Cu+ by ascorbic acid,and then Cu+ reacted with I- to form the precipitation of CuI.The precipitation of CuI was quantificationally adsorbed on the surface of Ms-M of (OTMAB+·I-) and was floated above water phase, the liquid-solid phases were formed with clear interface. In this condition, K+,Na+,Ca2+,Mg2+, Zn2+,Co2+,Al3+,Mn2+,Ni2+ and Fe2+ could not be floated.Therefore, Cu2+ was separated completely from the above metal ions.A new spectrophotometric method of determination of trace copper by flotation separation using microcrystalline adsorption system loaded with CuI was established.The proposed method has been successfully applied to the determination of Cu2+ in various environmental water samples, and the results agreed well with those obtained by AAS method.

An Accurate Method of Iodometric Titration to Measure Copper Valence of High- T C Superconductors

An Accurate Method of Iodometric Titration for Determining Oxygen Content of Superconducting Cuprates

Iodometric Titration for Determining the Oxygen Content of Samples Doped with Fe and Co

EXTRA OXYGEN DEFECT INDUCED BY Fe-DOPING IN Tl-SYSTEM SUPERCONDUCTOR

Study on Spectrophotometric Determination of Trace Copper after Flotation Separation Using Microcrystalline Adsorption System Loaded with Cui

The Study of a New Method to Determine Copper Ion by Square-Wave Voltammetry-Extraction Iodometry at the Liquid/Liquid Interfaces

Study on the Determination Method of the Content of Copper

A high-precision method to measure thermal conductivity of solids using reversible heat flux

Determination of trace amounts of copper in titanium dichloride molten salt by tungsten furnace AAS after solvent extraction.

Spectrophotometric determination of copper in fire smelting nickel substrate materials with bisoxaldihydrazone

A method of high sensitivity and in situ determination of trace cobalt(II) in water samples with salicyl fluorone.

Determination of the Content of Boron and Copper in the Tetrakis(Acetonitrile) Copper(I) Tetrafluoroborate Chemicals

Complexation-Supercritical Carbon Dioxide Extraction of Copper Ions from Solid Matrices with Thenoyltrifluoroacetone and Modifiers

Highly sensitive determination of copper in HeLa cell using capillary electrophoresis combined with a simple cell extraction treatment.

Co-precipitation approach to measure amount of $^{238}$U in copper to sub-ppt level using ICP-MS

PRECONCENTRATION OF TRACE COPPER IN WATER SAMPLES WITH FI-SOLVENT EXTRACTION AND AAS

New and clean strategy for the determination of Cu2+ in electroless copper plating baths.

Electrodeposition as a Preconcentration and Sample Preparation Technique for Trace Selenium and Tellurium Determination by X-Ray Fluorescence Spectrometry

Organic-ion-intercalated FeSe-based Superconductors

SIMULTANEOUS DETERMINATION OF COPPER AND NICKEL WITH DDTC SPECTROPHOTOMETRY IN THE PRESENCE OF TRITON X-100

Dithiothreitol-capped Fluorescent Gold Nanoclusters: an Efficient Probe for Detection of Copper(ii) Ions in Aqueous Solution.