Abstract:<p>With the rapid development of manufacturing technology in the fields such as aerospace, aviation, national defense, and automobiles, the demands for lightweight, toughening, and forming accuracy of products have increased. As one of the main defects in the plastic forming of thin-walled components, wrinkling failure has always been a key element in forming control. The sheet metal is restrained by the mold in actual forming process and the wrinkling is significantly affected by the boundary conditions. To study the effect of the mold constraints on the wrinkling failure in the actual forming process, a stretching wrinkling test of wedge plate with the boundary constraint conditions of mold was designed. By establishing the simulation model for wrinkling failure of sheet forming under mold constraints and its wrinkling limit diagram (WLD), the accurate prediction of sheet metal wrinkling failure form and the critical state in actual forming was realized. At the beginning of the research, the wedge plate tensile test was implemented for using as verification for simulation results, then the wrinkle simulation model of Buckle-Dynamic with the instability mode as the initial defect was established. By combining with the non-contact full-field strain measurement system DIC to obtain the strain data of the specimens in the test process, the accuracy of the simulation model was verified. On this basis, the critical wrinkling limit diagram (WLD) was established for the wrinkle partition on the wedge specimen, and the influence of stress state, stress loading path, principal compressive stress increment, principal stress ratio factors on the distribution and propagation direction of wrinkles, as well as the morphology and characteristics of WLD are discussed. The research content of this study is of guiding significance for the prediction of the actual wrinkling failure of sheet and shell forming.</p>

Filament-wound case deformation analysis and failure evaluation

Mechanical Analysis of Carbon Fiber Filament Wound Hydrogen Storage Vessel with Aluminum Alloy Liner

Mechanical Analysis and Optimal Design for Carbon Fiber Resin Composite Wound Hydrogen Storage Vessel With Aluminum Alloy Liner

Mechanical Analysis of Carbon Fiber Wound High Pressure Hydrogen Storage Vessel and Prestress Control in Manufacturing Process

Mechanical Analysis and Reasonable Design for Ti-Al Alloy Liner Wound with Carbon Fiber Resin Composite High Pressure Vessel

ANALYSIS-COMPUTATION ON MATERIAL NONLINEAR AND LARGE DEFORMATION OF FILAMENT-WOUND CASE

WITHDRAWN: Buckling and strain response of a filament winding composite cylindrical shell subjected to hydrostatic pressure: Analytical solution and testing

Numerical Analysis of the Deformation Behavior of Filament Wound Composite Shell Subjected to Internal Pressure

Analysis of Warping Failure in Tube Hydro-Forging

Investigation and Calculation Method for the Mechanical Properties of Filament Wound Profiles for Deformed Shield Tunnel Reinforcement

Analysis of stress and strength of filament wound solid rocket motor case

Strength and Failure Analysis of Fiber-Wound Composite Gas Cylinder via Numerical Simulation

Bursting problem of filament wound composite pressure vessels

Consolidation and Warpage Deformation Finite Element Analysis of Filament Wound Tubes

Multi-scale Progressive Damage and Failure Behavior Analysis of Three-Dimensional Winding SiC Fiber-Reinforced SiC Matrix Composite Tube

Research on the establishment and influence mechanism of critical wrinkling limit diagram (WLD) of plate and shell forming under mold constraints

Experiment Study of Stiffness Degradation for Damaged Composite Laminates

Use elements birth and death method to analyze the multi-layer filament winding case

Damage and Failure in Carbon Fiber-Reinforced Epoxy Filament-Wound Shape Memory Polymer Composite Tubes under Compression Loading

Experimental study of cylindrical case impacted by disk fragments

Investigation on Mechanical Behavior of Filament-Wound Cfrp Tubes