Abstract:This paper reports the simulation of an electron gun. The effects of some parameters on the beam quality were studied and optimal choices were identified. It gives numerical beam qualities in common electrostatic triode gun, and the dependences on design parameters such as electrode geometries and bias voltages to these electrodes are shown. An electron beam of diameter 5 mm with energy of five kilo electron volt was assumed for simulation process. Some design parameters were identified as variable parameters in the presence of space charge. These parameters are the inclination angle of emission electrode, the applied voltage to focusing electrode, the gap width between the emission electrode and the focusing electrode and the diameter of the focusing electrode. The triode extraction system is designed and optimized by using CST software (for Particle Beam Simulations). The physical design of the extraction system is given in this paper. From the simulation results, it is concluded that the inclination angle of the emission electrode is optimized at twenty two point five degrees, the applied voltage to the focusing electrode was optimized and found at minus sixteen volts, also, the separation distance (gap between emission electrode and focusing electrode) equals to four milli meter, and the diameter of the emission electrode is fourteen milli meter.

Theoretical investigation on the transient process in the RF guns with thermionic cathode

Experimental Study Of A Multi-Cavity Rf Gun With Thermionic Cathode

Studies on back bombardment of electrons in RF thermionic guns

Optimum Design of Electron Gun for 0.22-Thz Traveling Wave Tubes

R&D of a multi cavity RF gun with thermionic cathode for BFEL

RF design and high power tests of a new tsinghua photocathode RF GUN

Structure design and optimization of a compact C-band photocathode RF GUN

Current transmission and nonlinear effects in un-gated thermionic cathode RF guns

Development of a High-Gradient X-band RF Gun with Replaceable Field Emission Cathodes for RF Breakdown Studies

Status of the photocathode RF gun at tsinghua university

Development of an L-band Photocathode RF Gun at Tsinghua University

Laser Triggered RF Breakdown Study Using an S-band Photocathode Gun

Analysis and Experiments of a Waveguide Post's Influence on Photocathode RF Gun

Research and Fabrication of the Photocathode Used in DC-SC Photocathode RF Electron Gun

Space-Charge Dominated Photoemission in High Gradient Photocathode RF Guns

Design and Low-Power RF Test of a C-band Cryogenic RF Gun

THE RESEARCH OF ELECTRON RF GUN BASED ON X-BAND DAW (DISK-AND-WASHER) ACCELERATING STRUCTURE

Development of S-band Photocathode RF Guns at Tsinghua University

Design and numerical simulation of thermionic electron gun

An Ultrahigh-Vacuum S-band Photocathode Radio-Frequency Electron Gun

Surface-Emission Studies in a High-Field RF Gun Based on Measurements of Field Emission and Schottky-Enabled Photoemission