Abstract:The solid dissolution of Fe atoms into Cu matrix induced by mechanical alloying and subsequent thermal decomposition of Fe atoms from the solid solution in composition of Fe60Cu40 have been studied by X-ray diffraction (XRD), Mossbauer spectroscopy and the extended X-ray absorption fine structure (EXAFS) technique. The disappearance of elemental Fe and Cu XRD peaks and the presence of FCC structural XRD peaks illustrate the formation of FCC-Fe60Cu40 solid solution. Meanwhile, the new sextet spectrum with a broadening hyperfine magnetic field distribution also demonstrates that the alloying is on an atomic level and there exist complex coordination environments in the solid solution. EXAFS results Further prove the reality of atomic alloying from the clear observation of Fe atoms taking on FCC coordination in the solid solution. Additionally, a large reduction in the first shell coordination number for a center iron atom but not for a center Cu atom indicates the composition non-uniformity, which suggests that Fe atoms enrich the surface while Cu atoms enrich the core of a FCC nanocrystal. The variation of Mossbauer spectra against the annealing temperatures during thermal decomposition indicates that the Fe atoms at the surface readily nucleate and cluster into alpha -Fe at a temperature slightly below 250 degreesC, whereas the Fe atoms in the core of nano-sized crystals first cluster into gamma -Fe cohering to the FCC matrix at a temperature about 350 degreesC and then transform to alpha -Fe for further annealing at a higher temperature or for a longer time. (C) 2001 Elsevier Science B.V. All rights reserved.

Study on synthesis and microstructure of Fe-Cu embedded clusters

Achieving Homogeneous Fe Distribution and High Strength in Cu-Fe Composite Consolidated by Powder Rolling

Deformation of Fe and Ag Precipitates in Cu Matrix

Co-precipitated Ni/Mn Shell Coated Nano Cu-rich Core Structure: A Phase-Field Study

A Novel Synthetic Strategy of Fe@Cu Core-Shell Microsphere Particles by Integration of Solid-State Immiscible Metal System and Low Wettability

Atomic scale study of CU clustering and pseudo-homogeneous Fe-Si nanocrystallization in soft magnetic FeSiNbB(CU) alloys

Facile Route to Preparation of Fe-Co Microclusters with Highly Enhanced Magnetic Performances

Theoretical Study on the Aggregation of Copper Clusters on a Liquid Surface.

Microstructural Analysis of Gas Atomized Al-Cu Alloy Feedstock Powders for Cold Spray Deposition

Mechanical Alloying, Fine Structure and Thermal Decomposition of Nanocrystalline Fcc-Fe60cu40

Co-deposition of atomic clusters of different size and composition.

Unraveling the Atomic Structure of Ultrafine Iron Clusters

Microstructure and Mechanical Behavior of Quaternary Eutectic α+θ+Q+Si Clusters in As-Cast Al-Mg-Si-Cu Alloys

Controlled Formation of Mass-Selected Cu-Au Core-Shell Cluster Beams.

Atomic Scale Insights into the Rapid Crystallization and Precipitation Behaviors in FeCu Binary Alloys

Microstructural Evolution of Gas Atomized Fe-25cr-3. 2c Alloy Powders

Effect of Ag addition on the as-cast microstructure of Cu–8wt.% Fe in situ composites

Molecular Dynamics Simulation of Energetic Cu55 Clusters Deposition on a Fe (0 0 1) Surface

Metastable Structures of Immiscible System Induced by Mechanical Alloying

Microstructure and properties of Cu-50Fe alloy produced by chemical co-precipitation and powder metallurgy

In Situ Study of Copper Electrodeposition on A Single Carbon Fiber