Abstract:MgNi-based alloys have been regarded as very promising anode material for nickel-metal hydride battery owing to their electrochemcial capacity much higher than that of AB(5) alloys. However, Mg-Ni alloy anodes generally suffer very serious capacity decay in cycling, which is previously ascribed to the corrosion of Mg in alkali electrolyte in the past decades. To further reveal the capacity fading mechanism of MgNi-based alloys, the electrochemcial hydrogen storage properties of Mg2Ni and amorphous Mg50Ni50 alloys and their microstructural evolution during cycling were comparatively studied. It has been firstly demonstrated that it is the amorphous MgNi phase instead of Mg2Ni phase contributes to electrochemical discharge capacity, because the Mg2NiH4 hardly released hydrogen under electrochemcial conditions. Then, it has been found that the charge input level has significant effect on the cyclic performance of amorphous Mg50Ni50 alloy anode. At full charge of 500 mAh g(-1), the amorphous MgNi phase easily crystallized to the nanocrystalline Mg2NiH4, which leaded to the capacity decay immediately. Comparatively, with the low charge input of 100 mAh g(-1), the discharge capacity of amorphous Mg50Ni50 alloy remained almost unchanged for 425 cycles. The excellent cyclability is attributed to the less hydrogenation-induced crystallization at low charge input. This work clearly demonstrates that the hydrogenation-induced crystallization is a dominating reason for the electrochemical capacity decay in the milled amorphous Mg-Ni anode. It provides a new approach to improve the electrochemcial properties of Mg-Ni alloy electrode by inhibiting the hydrogenation-induced crystallization. (C) 2019 Elsevier Ltd. All rights reserved.

The Relation Between the Discharge Capacity and Cycling Number of Mechanically Alloyed MgxNi100−x Amorphous Electrode Alloys

The Reduction of Cycling Capacity Degradation of Mg–Ni-based Electrode Alloys by Fe Substitution

Corrosion Mechanism of Mechanically Alloyed Mg50ni50 and Mg45cu5ni50 Alloys

A study of the degradation of the electrochemical capacity of amorphous Mg50Ni50 alloy

An electrochemical investigation of mechanical alloying of MgNi-based hydrogen storage alloys

Electrode Characteristics of Non-Stoichiometric Ml(Nimnalfe)(X) Alloys

Electrochemical properties of amorphous Mg–Fe alloys mixed with Ni prepared by ball-milling

Influence of the material processing on the electrochemical properties of cobalt-free Ml(NiMnAlFe)5 alloy

Effects of Surface Modification on the Electrode Behavior of Amorphous CeMg12 Alloys

Microstructure and electrochemical properties of amorphous Mg-Fe-Ni hydrogen storage electrode material

Cycling durability and degradation behavior of La–Mg–Ni–Co-type metal hydride electrodes

The Effects of Partial Substitution of Mn by Cr on the Electrochemical Cycle Life of Ti-Zr-V-Mn-Ni Alloy Electrodes of a Ni/MH Battery

Microstructures and electrochemical hydrogen storage properties of novel Mg–Al–Ni amorphous composites

The Electrochemical Evaluation of Ball Milled MgNi-based Hydrogen Storage Alloys

Hydrogenation and Crystallization of Amorphous Phase: A New Mechanism for the Electrochemical Capacity and Its Decay in Milled Mg-Ni Alloys

Function of Al on the Cycling Behavior of the La–Mg–Ni–Co-type Alloy Electrodes

Electrical cycling characteristics of high-entropy energy storage Mg-Y-Ni-Cu alloys with different degrees of amorphization for Ni-MH batteries

Microstructure and electrochemical properties of amorphous composites of ball-milled Mg2Ni0.95Sn0.05 + x wt% Ni

Preparations and Electrochemical Properties of Amorphous Ti-Al Alloys

Effects of Surface Coating on the Electrochemical Properties of Amorphous CeMg12 Composite

Influence of Annealing Treatment on Microstructure and Cycling Stability of La-Rich Ml(Nicomnal)(5) Alloy Electrode for Ni/Mh Batteries