Abstract:Liquid atomization is applied in nanostructure dense coating technology to inject suspended nano-size powder materials into a suspension plasma spray (SPS) torch. This paper presents the effects of the atomization parameters on the nanoparticle processing. A numerical model was developed to simulate the dynamic behaviors of the suspension droplets, the solid nanoparticles or agglomerates, as well as the interactions between them and the plasma gas. The plasma gas was calculated as compressible, multi-component, turbulent jet flow in Eulerian scheme. The droplets and the solid particles were calculated as discrete Lagrangian entities, being tracked through the spray process. The motion and thermal histories of the particles were given in this paper and their release and melting status were observed. The key parameters of atomization, including droplet size, injection angle and velocity were also analyzed. The study revealed that the nanoparticle processing in SPS preferred small droplets with better atomization and less aggregation from suspension preparation. The injection angle and velocity influenced the nanoparticle release percentage. Small angle and low initial velocity might have more nanoparticles released. Besides, the melting percentage of nanoparticles and agglomerates were studied, and the critical droplet diameter to ensure solid melting was drawn. Results showed that most released nanoparticles were well melted, but the agglomerates might be totally melted, partially melted, or even not melted at all, mainly depending on the agglomerate size. For better coating quality, the suspension droplet size should be limited to a critical droplet diameter, which was inversely proportional to the cubic root of weight content, for given critical agglomerate diameter of being totally melted.

Pressurization and aspiration phenomena in process of gas atomization

Formation Mechanism of the Pressure Zone at the Tip of the Melt Delivery Tube During the Spray Forming Process

INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER

Measurement of Atomization Characteristics on Water Mist Fire Suppression Nozzle

Effects of Atomization Injection on Nanoparticle Processing in Suspension Plasma Spray

Phenomenological Study of the Atomization Process in Pre‐Filming Nozzles Typically Used for Steel Atomization

Investigation on the Influence of Pressure on Enhancing Atomization Effect of Molten Metal Stream

Simulation of Supersonic High-Pressure Gas Atomizer for Metal Powder Production

Study on the Atomization Characteristics of High-pressure Nozzle with an In-line Distributor

Research Advances in Close-Coupled Atomizer Flow and Atomizing Mechanisms

Three-Dimensional Simulation Of Effervescent Atomization Spray

Impact Mechanism of Gas Temperature in Metal Powder Production Via Gas Atomization

Investigation of electrostatic-assisted ultrasonic atomization and spraying

Experimental Study on Spray Characteristics of the Pressure- Swirl Atomizer with Small Atomizing Mass Flow

INVESTIGATION OF GAS-DISSOLVING EFFECT ON THE SPRAY-FORMATION OF A STEADY-JET

Effect Of Atomization Pressure On Flow Rate And Droplet Diameter Of Small-Bore Atomizing Nozzle

Experimental study on the flow field distribution characteristics of a gas–liquid swirl coaxial injector under ambient pressure

Airblast Atomization Of The Twin-Fluid Atomizer

Dynamic Behaviors of Gas Velocity Field during Metal Atomization

The Orifice Flow Pattern, Pressure Characteristics, and Their Effects on the Atomization of Fuel Containing Dissolved-Gas

Effect of static head and pressure on atomization droplets size in spray forming: theory analysis