Abstract:The effect of nozzle surface features on the overall atomization behavior of a liquid jet is analyzed in the present computational work by adopting three representative geometries, namely a single X-ray tomography scan of the Engine Combustion Network’s Spray A nozzle (Unprocessed), a spline reconstruction of multiple scans (Educated), and a purely external flow configuration. The latter configuration is often used in fundamental jet atomization studies. Numerically, the two-phase flow is solved based on algebraic volume-of-fluid methodology utilizing the OpenFoam solver, interFoam. Quantitative characterization of the surface features concerning the first two geometries reveals that while both of them have similar levels of cylindrical asymmetries, the nozzle configuration pertaining to the Unprocessed geometry has much larger surface features along the streamwise direction than the Educated geometry. This produces for the Unprocessed configuration a much larger degree of non-axial velocity components in the flow exiting the orifice and also a more pronounced disturbance of the liquid surface in the first few diameters downstream of the nozzle orifice. Furthermore, this heightened level of surface destabilization generates a much shorter intact liquid core length, that is, it produces faster primary atomization. The surprising aspect of this finding is that the differences between the Unprocessed and Educated geometries are of [Formula: see text](1) μm, and they are able to produce [Formula: see text](1) mm effects in the intact liquid core length. In spite of more pronounced atomization for the Unprocessed geometry, the magnitude of the turbulent liquid kinetic energy is roughly the same as the Educated geometry. This highlights the important role of mean field quantities, in particular, non-axial velocity components, in precipitating primary atomization. At the other end of the spectrum, the external-only configuration has the mildest level of surface disturbances in the near field resulting in the longest intact liquid core length.

Formation Mechanism of the Pressure Zone at the Tip of the Melt Delivery Tube During the Spray Forming Process

Measurement of Atomization Characteristics on Water Mist Fire Suppression Nozzle

INVESTIGATION OF ATOMIZATION PERFORMANCE ON A CENTRIFUGAL FUEL SLINGER WITH A PHASE DOPPLER ANEMOMETER

Study on the Atomization Characteristics of High-pressure Nozzle with an In-line Distributor

Flow and spray characteristics of a gas–liquid pintle injector under backpressure environment

Three-Dimensional Simulation Of Effervescent Atomization Spray

Experimental study on microscopic characteristics of impinging spray at elevated ambient pressure conditions during development

Liquid Jet Formation During a Suspended Liquid Suction Process

Gas–liquid coaxial atomization with swirl in high-pressure environments

Jet Formation During the Gas Penetration Through a Thin Liquid Layer

Theoretical Investigation of the Influence of Liquid Physical Properties on Effervescent Atomization Performance

Morphology Analysis on Multi-Jet Flash-Boiling Sprays under Wide Ambient Pressures

Atomization and droplet dynamics of a gas-liquid two-phase jet under different mass loading ratios

Numerical simulation of working process and gas-liquid interaction mechanism of air assisted nozzle

Airblast Atomization Of The Twin-Fluid Atomizer

Experimental study on the atomization characteristics and dust removal efficiency of a fan-shaped nozzle for purifying working environment

The effect of nozzle internal flow on spray atomization

Phenomenological Study of the Atomization Process in Pre‐Filming Nozzles Typically Used for Steel Atomization

Experimental Study on a New-type of Fan-shaped Spray Atomizer

Investigation on the Influence of Pressure on Enhancing Atomization Effect of Molten Metal Stream

Spray Characterization of a Preheated Bio-Oil Surrogate at Elevated Pressures