Abstract:Homogenously doped and mixed yttria stabilized zirconia, YSZ (with 3 and 10mol% Y2O3 known as 3YSZ and 10YSZ) and NiO/10YSZ co-precipitates (nominally corresponding to 7, 12, 24, 30, 35 and 45vol.% Ni metal), were synthesized using a continuous hydrothermal flow synthesis (CHFS) system which uses a stream of superheated water at 450°C and 24.1MPa as a reaction medium to cause rapid precipitation of metal oxide nanoparticle co-precipitates from a mixed metal salt solution. All products were obtained directly from the outlet of the CHFS reactor as a slurry, which was then cleaned and freeze-dried prior to further processing. The highly crystalline nano-powdered products were characterized using a range of analytical methods, including: powder X-ray diffraction (XRD), energy dispersive spectroscopy (EDS), transmission electron microscopy (TEM), Raman spectroscopy and BET surface area measurements. Spherical primary particles of 10YSZ and 3YSZ were observed under the TEM and found to be 5.0±0.8nm (range 3.2–6.3nm) and 6.2±1.4nm (range 3.3–8.4nm) in size, with measured BET surface areas of 160.6 and 241.7m2g−1, respectively. Sintering of the nano-powder co-precipitates was performed via spark plasma sintering (SPS) at 1100°C for 1min, leading to densities of ca. 98% for 10YSZ and ca. 96% for Ni/10YSZ cermets (all NiO was converted into Ni due to the reducing atmosphere of the SPS). The 24% Ni/10YSZ cermet was subjected to focused ion beam tomography, which allowed the 3D arrangement of the conducting Ni metallic network of the dense cermet to be elucidated, and showed that a complete 3D network of Ni existed throughout the dense cermet disk. Electrical conductivity tests showed that the samples exhibited higher than expected electrical conductivity (for such low metal content), e.g., the 24vol.% Ni-containing sample achieved an electrical conductivity of ∼200Scm−1 at the fuel cell operating temperature, which corresponds to an effective conductivity of ∼117Scm−1 if a porosity of 30% were to be introduced.

Novel Co-precipitation method to synthesize NiO-YSZ nanocomposite powder for solid oxide fuel cell

YSZ Thin Films Prepared by a Novel Powder Coating Process on Porous NiO-YSZ Cermet

Preparation And Properties Of Nio-Coated Ysz Anodes For Solid Oxide Fuel Cells

Preparation of NiO–YSZ composite powder by a combustion method and its application for cathode of SOEC

Preparation Of Nanosized Nio-Ysz Composite Powders By Situ-Precipitation Method

Preparation of Ni/Ysz Materials for Sofc Anodes by Buffer-Solution Method

Performance and Optimization of Ni/3 Mol% Y2O3-ZrO2 Anode Supported SOFC

Porous NiO–YSZ and Ni–YSZ composites fabricated using NiO–YSZ composite nanopowders and WO3 additive

Highly conductive low nickel content nano-composite dense cermets from nano-powders made via a continuous hydrothermal synthesis route

Application of 8YSZ Nanopowder Synthesized by the Modified Solvothermal Process for Anode Supported Solid Oxide Fuel Cells

Preparation of Pr0.35Nd0.35Sr0.3MnO3−δ/YSZ Composite Cathode Powders for Tubular Solid Oxide Fuel Cells by Microwave-Induced Monomer Gelation and Gel Combustion Synthesis Process

Optimization of Ni YSZ Anodes for Tubular SOFC by a Novel and Efficient Phase Inversion-Impregnation Approach

A Novel Method to Purposely Modify the Anode/Electrolyte Interface in Solid Oxide Fuel Cells

Preparation and Performance of Tri-layer Composite Anode Supported Fuel Cell

Application of Yttria Stabilized Zirconia (8YSZ) and NiO Precursors for Fabrication of Composite Material for Anode-Supported SOFCs

Reactive Sputtered NiO-YSZ Anode Functional Layer for Thin Film Low-Temperature Solid Oxide Fuel Cell

Anodic polarization creates an electrocatalytically active Ni anode/electrolyte interface and mitigates the coarsening of Ni phase in SOFC

Novel BaO-decorated carbon-tolerant Ni-YSZ anode fabricated by an efficient phase inversion-impregnation approach

Temperature-dependent chemical incompatibility between NiO-YSZ anode and alkaline earth metal oxides: Implications for surface decoration of SOFC anode

Preparation of Ni–YSZ Cermet through Reduction of NiO–YSZ Ceramic for SOFC Anode

Preparation of Ni/YSZ for SOFC Anodes by Buffer-Solution Method