Abstract:Natural gas, known for its high combustion efficiency and low CO 2 emissions, is experiencing a significant increase in both market share and application range. Despite these advantages, there are also challenges emerged during the combustion process, including occurrence of high flame temperature, difficulty in controlling nitrogen oxide emissions, combustion instability, and a tendency to backfire. To address these issues and achieve clean and stable burning, a novel 14MW water-cooled pre-mixed burner has been developed. In-depth simulations are conducted to assess the impact of various structural and operating parameters on combustion and pollutant emission characteristics. Results indicate that the combustion temperature follows a "W" shape with height of the low cooling component while its width governs combustion stability. Gas inlet spacing influences the flame center position and anti-backfire performance. The flare angle of gas channels determines the minimum ignition energy of the mixed gas fuel which affects ignition point and flame center position. Although large height of high cooling component contributes to low NO x emissions at the gas outlet, the resultant low temperature is undesirable for combustion stability. Further examinations of operating parameters through simulations reveal that combustion temperature initially decreases and then increases with excess air coefficient, while a significant decrease is noted with lower operating load. The premixed water-cooled technology could achieve low-NO x emissions to 2.89 mg·Nm -3 with the combustion temperature controlled at 1642K. This study provides valuable data for the design of low-NO x gas burners, serving as a reference for achieving clean and stable combustion of gas fuel.

Influence of Over Fire Air and Water/Steam on NOx Emission and Flame Stability in a Heavy Oil Fired Combustion System

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Quantitative Assessment of Flame Stability Through Image Processing and Spectral Analysis

Oxy-fuel combustion of heavy oil based on OH - PLIF technique

Combustion Instability and Emission Characteristics of Spray Flame under Flue Gas Jet

The integrated analysis of economy and safety on SOFA running mode of a 600MWe boiler

Flamelet LES of a Swirl-Stabilized Multi-Stream Pulverized Coal Burner in Air and Oxy-Fuel Atmospheres with Pollutant Formation

Impact of Ofa on Combustion and Nox Emissions of A Large-Scale Laboratory Furnace Fired by A Heavy-Oil Swirl Burner

Emission on NOx in High Temperature Combustion with Low Oxygen Concentration

Combustion stability and NO x emission characteristics of three combustion modes of pulverized coal boilers under low or ultra-low loads

Experimental Study of the "Oil-in-water" Type Emulsified Heavy Oil Combustion and Emissions

Flame stability monitoring and characterization through digital imaging and spectral analysis

Numerical Prediction of Swirl Burner Geometry Effects on NOx Emission and Combustion Instability in Heavy Oil-Fired Boiler

The turbulent flame structure in a steam diluted H 2 /Air micromix flame

Ignition and Flame Stablization Test for W-flame Boiler with Double Cyclone Burner Using Tiny-oil Ignition Technology

Heavy Fuel Oil Combustion Characteristics Evaluation in Various Swirling Flow Conditions

Oscillating Combustion and Flame Modes in Different Oscillating Frequencies

Influence of Separated Overfire Air Ratio and Location on Combustion and NOx Emission Characteristics for a 600 MWe Down-Fired Utility Boiler with a Novel Combustion System

Numerical Simulation of the OFA Effect on Combustion in a 600 MWe Boiler with Centrally Fuel Rich Burners

Numerical Studies of a Water-cooled Premixed Burner for Low NO x Combustion of Natural Gas

Influence of Optimizing OFA on NOx Formation by Numerical Simulation