Abstract:The present article investigates the interactions between the pilot and main flames in a novel stratified swirl burner using both experimental and numerical methods. Experiments are conducted in a test rig operating at atmospheric conditions. The system is equipped with the BASIS (Beihang Axial Swirler Independently-Stratified) burner fuelled with premixed methane-air mixtures. To illustrate the interactions between the pilot and main flames, three operating modes are studied, where the burner works with: (i) only the pilot flame, (ii) only the main flame, and (iii) the stratified flame (with both the pilot and main flames). We found that: (1) In the pilot flame mode, the flame changes from V-shape to M-shape when the main stage is switched from closed to supplying a pure air stream. Strong oscillations in the M-shape flame are found due to the dilution of the main air to the pilot methane flame. (2) In the main flame mode, the main flame is lifted off from the burner if the pilot stage is supplied with air. The temperature of the primary recirculation zone drops substantially and the unsteady heat release is intensified. (3) In the stratified flame mode, unique beating oscillations exhibiting dual closely-spaced frequencies in the pressure spectrum. is found. This is observed within over narrow window of equivalence ratio combinations between the pilot and main stages. Detailed analysis of the experimental data shows that flame dynamics and thermoacoustic couplings at these two frequencies are similar to those of the unstable pilot flame and the attached main flame cases, respectively. Large Eddy Simulations (LESs) are carried out with OpenFOAM to understand the mechanisms of the time averaged flame shapes in different operating modes. Finally, a simple acoustic analysis is proposed to understand the acoustic mode nature of the beating oscillations.

Flame stability monitoring and characterization through digital imaging and spectral analysis

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Visualization of Multi-Regime Turbulent Combustion in Swirl-Stabilized Lean Premixed Flames

Quantitative Assessment of Flame Stability Through Image Processing and Spectral Analysis

Multi-bifurcation behaviors of stability regimes in a centrally staged swirl burner

Combustion Instability Detection Based on Multi-Signal Information Fusion for an Industrial Gas Turbine Combustor

Quantitative Measurement of the Stability of a Pulverized Coal Fired Flame Through Digital Image Processing and Statistical Analysis

A Simple Index Based Quantitative Assessment Of Flame Stability

A Fuzzy Synthetic Evaluation Method of Flame Stability Based on Time–Frequency Analysis and Higher-Order Statistics

Monitoring of a Swirl Burner by a Flame Detector and Flame Image Information

IMAGING DIAGNOSTICS OF COMBUSTION INSTABILITY IN PREMIXED SWIRLING COMBUSTION

Investigations into the Ignition Behaviors of Pulverized Coals and Coal Blends in a Drop Tube Furnace Using Flame Monitoring Techniques

On-line Tracking of Pulverized Coal and Biomass Fuels Through Flame Spectrum Analysis

Experimental Investigation on the Symmetry and Stabilization of Ethanol Spray Swirling Flames Utilizing Simultaneous PIV/OH-PLIF Measurements

Measurement and Identification of Flame Describing Function (FDF) Based on Parallel Subsystem Model

Numerical Study on the Stabilization of a Self-Sustaining Steady-State Premixed Cool Flame

Near blowout instabilities and identification based on multivariate analysis with high-speed multi-species optical diagnostic techniques

Oscillation frequency measurement of gaseous diffusion flames using electrostatic sensing techniques

Flame visualization and spectral analysis of combustion instability in a premixed methane/air-fueled micro-combustor

Flame interactions in a stratified swirl burner: flame stabilization, combustion instabilities and beating oscillations

Measurement of soot temperature, emissivity and concentration of a heavy-oil flame through pyrometric imaging