Abstract:It is difficult to simulate both the flow field and the chemical reaction using, respectively, the flow state and kinetics calculations and actually reflect the influence of the gas flow state on the chemical change in a selective catalytic reduction (SCR) system. In this study, the flow field and the chemical reaction were therefore coupled to simulate a full Cu-Zeolite SCR system and the boundary conditions of the simulation were set by a relevant diesel engine bench test which included the exhaust temperature, the mass flow, and the exhaust pressure. Then, the influence of the gas flow state on the NOx conversion efficiency was investigated. Specifically, an orthogonal experimental design was used to study the influence of the injection parameters (position, angle, and speed) on the NH3 distribution by establishing the NH3 uniformity coefficient γ at the SCR catalyst capture surface in the flow field simulation. Then, the velocity capture surface of the SCR catalyst front section was sliced into coupled data transfer interfaces to study the effects of exhaust temperature, ammonia to NOx ratio (ANR), and the NO2/NOx on the NOx conversion efficiency. This was used as guidelines to optimize the SCR system control strategy. The results showed that a 1150 mm injection position, a 45°injection angle, and a 23 m/s injection velocity provided the most uniform NH3 distribution on the SCR catalyst capture surface. For constant injection parameters, the NOx conversion efficiency was the highest when the exhaust temperature was 200°C-400°C, the ANR was 1.1, and NO2/NOx was 0.5.

Simulation Analysis of Fixed Bed Reactor for Au-Cu Non-Mercury Catalytic Acetylene Hydrochlorination

Simulation and Analysis of Fixed-Bed Reactor for Hydrochlorination of Acetylene

Modeling and Simulation of Commercial Catalytic Reformers

Simulation, sensitivity analysis and optimization of a continuous catalytic reforming process

Modeling, Simulation and Optimization of Commercial Naphtha Catalytic Reforming Process

Modeling and Simulation Research onm-Xylene Oxidation Reactor

Lumped Kinetics Model and Its On-Line Application to Commercial Catalytic Naphtha Reforming Process

The Kinetics Model and Fixed Bed Reactor Simulation of Cu Catalyst for Acetylene Hydrochlorination

CFD simulation of cross flow in multi-tubular fixed-bed reactor of industrial level

Kinetics of Acetylene Hydrochlorination over Bimetallic Au–Cu/C Catalyst

Simulation Analysis of Gas-Solid Two-Phase Flow and Reaction in a Novel Catalytic Cracking Reactor

Simulation and Analysis of a Tubular Fixed‐Bed Fischer‐Tropsch Synthesis Reactor with Co‐Based Catalyst

The two-dimensional heterogeneous modeling for non-isothermal non-adiabatic fixed-bed reactor and the analysis by orthogonal collocation

Simulation and optimization of operating parameters of isothermal reaction process for acetylene hydrogenation

Deactivation of Au-Cu-K mercury-free catalyst in hydrochlorination of acetylene

Trimetallic Au-Cu-La/AC for Acetylene Hydrochlorination in a Multi-Tubular Fixed Bed Reactor

Modeling and Simulation of So2 Oxidation in A Fixed-Bed Reactor with Periodic Flow Reversal

Simulation of the flow field and the chemical reaction coupling of selective catalytic reduction (SCR) system using an orthogonal experiment

Acetylene Hydrogenation Processes Studied Using CFD in a Packed Bed Reactor

Evaluation and application of kinetic models for Cu-catalyzed acetylene hydrochlorination

Modeling and Simulation of a Three Phase Fixed Bed Catalytic Reactor for the Hydrogenation of 2-ethyl-hexenal