Abstract:In this study, the effect of ozone-based rounding was investigated for three random-pyramid texture height ranges for Silicon Heterojunction (SHJ) at the cell and module levels. In a first experiment, 5 ozone-based rounding process times (0, 2, 4, 6, 8 and 10 minutes) were applied to two texture-height ranges (Small and Medium) to observe variations in the reflection response of the wafers. In a second experiment, 3 ozone-based rounding treatment times (0, 2 and 6 minutes) were applied to three texture-height ranges (Small, Medium and Large) and to observe the results both on the cell and on the module levels. The first experiment has shown that ozone-based rounding increases reflection and has a more pronounced effect for smaller than larger sized texture-heights. An increase in the minimum wavelength of reflection is seen after the Transparent Conductive Oxide (TCO) deposition, indicating that shorter deposition times can be used. The results of the second experiment show that, even though the Short-Circuit Current (Jsc) decreases for the three textures with rounding time, it is compensated by an increase in the pseudo-Fill-Factor (pFF). A maximum is seen at the cell level for 2 minutes of rounding for the small and large texture sizes, but which is leveled at the module. In conclusion, these results indicate that 2 minutes of ozone-based rounding can be beneficial for the cell’s final efficiency as the improvement in passivation still compensates the optical losses resulting in a lower Jsc.

Texturization and Rounded Process of Silicon Wafers for Heterojunction with Intrinsic Thin-Layer Solar Cells

Investigation of Texturization for Monocrystalline Silicon Solar Cells with Different Kinds of Alkaline

TEXTURIZATION OF MONOCRYSTALLINE SILICON FOR SOLAR CELLS

Modification of Surface Morphology of A Textured Silicon Substrate and Its Application in Heterojunction Solar Cells

INFLUENCE OF SUB-SURFACE DAMAGE ON TEXTURING OF MONOCRYSTALLINE SILICON WAFERS FOR SOLAR CELLS

A Simple Texturization Approach for Mono-Crystalline Silicon Solar Cell with Low Tmah Concentration Solution

Improvement of conversion efficiency of multicrystalline silicon solar cells by incorporating reactive ion etching texturing

Aqueous HF-(HCl)-Cl2 Mixtures for Saw-Damage Removal and Spray Texturing of Monocrystalline Silicon Solar Cells

Electrochemical Oxidation Pre-Treatment for Wet Texturing of Monocrystalline Silicon Solar Cells

Acid Texturing of Large Area Multi-Crystalline Silicon Wafers for Solar Cell Fabrication

Effects of IPA on texturing process for mono-crystalline silicon solar cell in TMAH solution

Texturization of Cast Multicrystalline Silicon for Solar Cells

Research of Texturization on Multi-crystalline Silicon Surface for Solar Cell

Performance Improvement of Graphene/Silicon Solar Cells via Inverted Pyramid Texturation Array

Impact of Texture Height and Ozone-Based Rounding on Silicon Heterojunction Solar Cells Performance

Texturization of Mono-Crystalline Silicon Solar Cells in TMAH Without the Addition of Surfactant

Simple Smoothing of the Bottom Silicon Surface Using Wet Chemical Etching Methods for Epitaxial III‐V/Silicon Tandem Manufacturing

A Continuous, Single-Face Wet Texturing Process for Industrial Multicrystalline Silicon Solar Cells Using a Surfactant Treated Photoresist Mask

Investigation of Texturing Industrial Mono-Crystalline Silicon Solar Cells

Impact of Surface Treatments on the Passivation Effect for N-Type Crystalline Silicon in Heterojunction Solar Cells

Performance Improvement of PEDOT:PSS/N-Si Heterojunction Solar Cells by Alkaline Etching