Abstract:Anisotropic ductile fracture is one of the critical issues in the precision plastic forming of lightweight sheet metals. In this work, a new anisotropic ductile fracture model is developed by introducing the anisotropic stress triaxiality into the weight equation of the shear-controlled ductile fracture criterion. In an attempt to consider the effect of material anisotropy on stress state, the proposed fracture model is constructed in the anisotropic stress state form. The proposed anisotropic fracture model is used to characterize the anisotropic ductile fracture behavior of the AA7075-T6 sheet with a thickness of 2.0 mm under various stress states at room temperature. A series of uniaxial tensile tests are conducted using the in-plane shear specimen, the specimen with a central hole, and the plane strain grooved specimen to experimentally investigate the ductile fracture of AA7075-T6 along rolling, diagonal, and transverse directions. The proposed fracture model is calibrated by fracture strains determined from the hybrid experimental-numerical approach. With the calibrated fracture model, the aniso-tropic ductile fracture behaviors of AA7075-T6 over a wide range of stress states are predicted and compared with experimental measurements. The results show that the proposed fracture model successfully captures the anisotropic ductile fracture behavior of AA7075-T6 under various stress states at room temperature. Further-more, to further illustrate the fracture predictive capability of the proposed fracture model, the predicted anisotropic fracture forming limit diagram is compared with the experimental forming limit strains obtained from the literature. Reasonable agreement is shown between literature data points and predicted fracture forming limit diagram. Accordingly, the proposed model has a great advantage in quantitative characterizing the anisotropic ductile fracture of high-strength aluminum alloy sheets under various loading conditions.

Use of a modified Gurson model for the failure behaviour of the clinched joint on Al6061 sheet

A modified Gurson model and its application to punch-out experiments

Experimental and Numerical Research for the Failure Behavior of the Dieless Clinching Joints

Study on the Analytical Model of Joint Strength Prediction of Flat-Clinching

Experimental and Numerical Research for the Failure Behavior of the Clinched Joint Using Modified Rousselier Model

Ductile fracture prediction in aluminium alloy 5A06 sheet forming based on GTN damage model

Analysis of Metallic Ductile Fracture by extended Gurson models

Investigation of the Gurson Damage by Using the Indentation Fatigue Tests

Tension–torsion fracture experiments – Part II: Simulations with the extended Gurson model and a ductile fracture criterion based on plastic strain

Anisotropic Gurson-Tvergaard-Needleman model considering the anisotropic void behaviors

Research of the Gurson damage model of the different yield functions during the deep-drawing process

A New Ductile Fracture Model for Q460C High-Strength Structural Steel under Monotonic Loading: Experimental and Numerical Investigation

Extended GTN Model for Predicting Ductile Fracture under a Broad Range of Stress States

Modified Gtn Model for A Broad Range of Stress States and Application to Ductile Fracture

Modeling of metallic shear failure by void-based meso-damage model

Calibration procedures for a computational model of ductile fracture

Numerical analysis of ductile fracture in stretch bending of AA6061-T6 aluminum alloy sheet using GTN damage model

Ductile Fracture in Thin Sheet Metals: a FEM Study of the Sandia Fracture Challenge Problem Based on the Gurson–Tvergaard–Needleman Fracture Model

Modeling Anisotropic Ductile Fracture of AA7075-T6 Sheet for Sheet Metal Forming Considering Anisotropic Stress State

Prediction of Fracture Behavior of 6061 Aluminum Alloy Based on GTN Model

Failure analysis of single-point butt clinched joint with dissimilar aluminium alloy sheets