Abstract:This study aims to explore the influence mechanism of interfacial reaction in BF. The interfacial reaction behavior was analyzed, the thermodynamic and evolution processes of interfacial reaction were studied, and the influence of interfacial reaction on BF was discussed. The results show that: The desulfurization reaction mechanism can be considered as the electron transfer at slag-iron interface. The viscosity of molten iron shows a decreasing trend with the increase of sulfur content, and the surface tension of molten iron will rapidly decrease with sulfur content, so the interfacial reaction rate will be accelerated. The reduction of FeO occurs at slag-carbon interface, the content of FeO in slag often shows a decreasing trend along the height direction of BF, the erosion rate of carbon brick will increase under the condition of slag with high FeO content. The reduction of SiO 2 is achieved with the help of two gas-phase compounds SiO and SiS. The average Si content in molten iron decreases with the increase of BF volume, which indicates that the large BF is more conducive to achieving low-carbon smelting. The reduction of TiO 2 is carried out at the slag-carbon interface step by step, the valence state of Ti element gradually decreases. The iron-carbon interface in hearth has a significant effect on the erosion of carbon brick and the state of hearth. The wetting and erosion process at iron-carbon interface is clarified based on the cycle model, the carbon brick is eroded in this cycle. The time for the carburization of molten iron is limited, so the carbon content of molten iron cannot reach saturation, although there are a large number of iron-carbon interfaces in hearth. The change trend of maximum temperature on sidewall is opposite to the actual carbon content, the change in carburization behavior at iron-carbon interface is the essential reason for the fluctuation of erosion rate of carbon brick.

Interactions of high-chromia refractory materials with infiltrating coal slag in the oxidizing atmosphere of a cyclone furnace

Interactions of Cr2O3–Al2O3–ZrO2 refractory with slags in an entrained-flow coal-water slurry gasifier

Corrosion of high-chrome refractory materials by high-sodium slag in an entrained-flow gasifier

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Microstructure evolution, mechanical characteristics and erosion behavior of Cr2O3–Al2O3–MgO–ZrO2 refractories in molten reduction slag

Corrosion in high alumina refractory serviced in a bench-scale entrained flow gasifier

The Mineralogy Analysis Of Ash Deposition In Refractory Zones In A W-Flame Boiler

Modeling of Multiphase Reaction and Slag Flow in Single-Burner Coal Water Slurry Gasifier

Influence of Fe 2 O 3 and Atmosphere on Crystallization Characteristics of Synthetic Coal Slags

Corrosion mechanism of cement-bonded Al2O3–MgAl2O4 pre-cast castables in contact with molten steel and slag

Corrosion behavior of CaO–Al2O3–SiO2–MgO-Cr2O3 slag on MgO refractory brick for smelting of chromite

Microstructure, phase evolution, mechanical properties and slag corrosion resistance of ZrO2 reinforced Al2O3–Cr2O3 composites

Corrosion mechanism of magnesia-chrome refractory bricks with FetO-SiO2-Cr2O3 copper converter slag

Degradation behaviors of cement-free corundum-spinel castables in Ruhrstahl Heraeus refining ladle: Role of infiltrated steel

Research on Slag‐resistance of ZrN‐SiAlON‐SiC‐C Composite Refractory in Different Atmospheres

Investigation of Slagging Characteristics on Middle and Low Temperature Heat Transfers by Burning High Sodium and Iron Coal

Coal ash slag wettability on Cr2O3-Al2O3 -ZrO2 bricks and its penetration behavior

Interfacial reaction behavior in blast furnace and analysis of influence mechanism

Enhancement, application, and challenges of chromium–corundum high‐temperature refractories

Experimental Study on Fouling and Slagging Behaviors During Oxy-Fuel Combustion of High-Sodium Coal Using a High-Temperature Drop-Tube Furnace

Effect of Phase Composition on Leaching Behavior and Mechanical Properties of Ceramics from Ferrochrome Slag and Tundish Slag