Feasibility of Using Sputtered Alox, Film As Gate Insulator for High Performance Ingazno-Tfts

Jun Li,Jian-Hua Zhang,Xing-Wei Ding,Wen-Qing Zhu,Xue-Yin Jiang,Zhi-Lin Zhang
DOI: https://doi.org/10.1016/j.spmi.2013.10.032
IF: 3.22
2014-01-01
Superlattices and Microstructures
Abstract:We reported on the electrical and surface characteristics of radio frequency (rf) AlOx film and their applications in InGaZnO-based thin film transistors (TFTs). By optimizing the rf power, AlOx film with the low leakage current density and smooth surface was obtained. The leakage current density for the 180 W AlOx film was observed to be similar to 2.0 x 10(-9) A/cm(2) at electrical field strength of 2 MV/cm. The root mean square (rms) roughness of 180 W AlOx film was about 1.36 nm. InGaZnO-TFTs with different AlOx insulators were fabricated. The InGaZnO-TFT with 180 W AlOx insulator exhibits a field-effect mobility of 6.9 cm(2)/V s, a threshold voltage of 4.2 V, an on/off ratio of 2.7 x 10(7), and a much smaller Vth shift of 6.6 V for 20 V bias stress duration of 10,800 s. The improvement of InGaZnO-TFT with 180 W AlOx film is attributed to smooth surface of AlOx film and smaller trap charges. The results indicate that AlOx is a promising candidate insulator for InGaZnO-TFTs. (C) 2013 Elsevier Ltd. All rights reserved.
What problem does this paper attempt to address?