Abstract:Highly active samarium manganese perovskite oxides were successfully prepared by employing self-molten-polymerization, coprecipitation, sol-gel, and impregnation methods. The physicochemical properties of perovskite oxides were investigated by XRD, N-2 adsorption-desorption, XPS, and H-2-TPR. Their catalytic performances were compared via the catalytic oxidation of toluene. The perovskite prepared by self-molten-polymerization possessed the highest catalytic capacity, which can be ascribed to its higher oxygen adspecies concentration (O-latt/O-ads = 0.53), higher surface Mn4+/Mn3+ ratio (Mn4+/Mn3+ = 0.95), and best low-temperature reducibility (H-2 consumption = 0.27; below 350 degrees C). The most active catalyst also exhibited good cycling and long-term stability for toluene oxidation. After a multistep cycle reaction and a long-term reaction of 42 h, the toluene conversion maintained above 99.9% at 270 degrees C. Mechanistic study hinted that lattice oxygen was involved in toluene oxidation. The oxidation reaction was dependent on the synergism of lattice oxygen, adsorbed oxygen, and oxygen vacancies. The degradation pathway of toluene, researched by diffuse reflectance infrared Fourier transform spectroscopy and online mass spectrometry technologies, demonstrated that a series of organic byproducts existed at a relatively low temperature. This work provides an efficient and practical method for selecting highly active catalysts and for exploring the catalytic mechanism for the removal of atmospheric environmental pollution.

Lamno3 Perovskite Oxides Prepared by Different Methods for Catalytic Oxidation of Toluene

Synthesis of Oxide Supported Lamno3 Perovskites to Enhance Yields in Toluene Combustion

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Catalytic Oxidation of 1,2-Dichloropropane over Supported Lamnox Oxides Catalysts

Synthesis Of Nanostructure Lamno3 And Lacoo3 Catalysts And Their Catalytic Activity In Oxidation Reaction

A Facile Method For In Situ Preparation Of The Mno2/Lamno3 Catalyst For The Removal Of Toluene

Enhanced Low-Temperature Activity of LaMnO3 for Toluene Oxidation: the Effect of Treatment with an Acidic KMnO4

Structural Characterization and Co Oxidation Activity of Nanostructured Lamno3 Catalysts

Effects of Preparation Methods on the Catalytic Performance of LaMn0.8Mg0.2O3 Perovskite for Methane Combustion

A Facile Method for Scalable Preparation of Mesoporous Structured SmMnO3 Perovskites Sheets for Efficient Catalytic Oxidation of Toluene

Catalytic Oxidation Of Vocs Over Smmno3 Perovskites: Catalyst Synthesis, Change Mechanism Of Active Species, And Degradation Path Of Toluene

Ozone catalytic oxidation of toluene over triple perovskite-type catalysts modified with KMnO4

Rapid Syntheses of Ultrafine Lamno3 Nano-Crystallites with Superior Activity for Catalytic Oxidation of Toluene

Enhanced Low-Temperature Activity of Toluene Oxidation over the Rod-like MnO2/LaMnO3 Perovskites with Alkaline Hydrothermal and Acid-Etching Treatment

Catalytic performance of rare earth nanometer materials LaMnO3+lambda

Tuning the crystallinity of the MnOx catalysts to promote toluene catalytic oxidation

B-Site modification of LaMn<sub>0.9</sub>Co<sub>0.1</sub>O<sub>3</sub>perovskite using a selective dissolution method in C<sub>3</sub>H<sub>6</sub>oxidation

Enhanced light-driven photothermocatalytic activity on selectively dissolved LaTi1−Mn O3+ perovskites by photoactivation

Transforming Plain LaMnO3 Perovskite into a Powerful Ozonation Catalyst: Elucidating the Mechanisms of Simultaneous A and B Sites Modulation for Enhanced Toluene Degradation.

A-site cations tailoring the activity of LnMnO 3 perovskites for CO and propane oxidation

Effects of the Morphology of MnO 2 Nanostructures on the Catalytic Oxidation of Toluene