Abstract:The impact of the boundary plane and impurity contamination on the recombination activity of Sigma3 boundaries in multicrystalline silicon (mc-Si) was studied by means of electron-beam-induced current (EBIC) technique. In the as-grown contamination-free mc-Si, the EBIC contrast of different Sigma3 boundaries was in the order of Sigma3{111}<Sigma3{110}<Sigma3{112}. This order may be attributed to the difference in the defect density of the Sigma3 boundaries due to the effect of the boundary plane. But the maximum EBIC contrast did not exceed 2% at 300 K, suggesting that the Sigma3 boundaries are originally electrically inactive and the boundary plane has no significant effect on their recombination activity. When contaminated with Fe at 900 degreesC, the EBIC contrasts of the Sigma3{110} and Sigma3{112} increased at 300 K, whereas that of the Sigma3{111} was still weak (<3%). This variation in the EBIC contrast may be related to the effect of boron and it is also indicated that the Sigma3{111} has the weakest gettering ability. When contaminated with Fe at 1100 degreesC, the EBIC contrasts of all the Sigma3 boundaries continued to increase and bright-denuded zones developed around the boundaries. The Sigma3 boundaries in the 1100 degreesC air-cooled mc-Si showed stronger EBIC contrasts and broader denuded zones than those in the 1100 degreesC quenched one. This phenomenon was explained in terms of the precipitation of Fe. The precipitation of Fe at grain boundaries (GBs) was affected by both the GB type and cooling rate, that is, Fe is easier to form precipitates onto the Sigma3{110} and Sigma3{112} boundaries during slow cooling. (C) 2005 American Institute of Physics.

Modulation of Electrical Characteristics at a Ni-contaminated Silicon Grain Boundary by Engineering the Metal Precipitates

Effect of Nickel Contamination on Grain Boundary States at a Direct Silicon Bonded (1 1 0)/(1 0 0) Interface

Electron-beam-induced Current Study of Grain Boundaries in Multicrystalline Si

Effect Of Au Contamination On The Electrical Characteristics Of A "Model" Small-Angle Grain Boundary In N-Type Direct Silicon Bonded Wafer

Recombination behavior of nickel in cast multicrystalline silicon

(Invited) Defects in Cast-Mono Crystalline Silicon

Electron-beam-induced current study of hydrogen passivation on grain boundaries in multicrystalline silicon: Influence of GB character and impurity contamination

Impact of Cu Contamination on the Electrical Properties of A Direct Silicon Bonded (110)/(100) Interfacial Grain Boundary

Grain Boundary Engineering of High Performance Multicrystalline Silicon: Control of Iron Contamination at the Ingot Edge

The characterization of high quality multicrystalline silicon by the electron beam induced current method

Influence of Nickel Precipitation on the Formation of Denuded Zone in Czochralski Silicon

Influence of gettering and passivation on uniformity of the electrical parameters in monolithic multicrystalline silicon solar cell

Electron-beam-induced current study of grain boundaries in multicrystalline silicon

Understanding the Effect of Impurities and Grain Boundaries on Mechanical Behavior of Si Via Nanoindentation of (110)/(100) Direct Si Bonded Wafers

Recombination Activity Of Sigma 3 Boundaries In Boron-Doped Multicrystalline Silicon: Influence Of Iron Contamination

Hydrogenation of Interface States at A Clean Grain Boundary in the Direct Silicon Bonded Wafer

The dislocation distribution characteristics of a multi-crystalline silicon ingot and its impact on the cell efficiency

The Nature of a Low Angle Grain-Boundary in a Si Bi-Crystal with Added Fe Impurities

Hydrogen passivation of Fe-related deep energy levels at a direct silicon-bonded (110)/(100) grain boundary

Process-induced defects in nitrogen doped Czochralski silicon in diode processes

Higher Quality Mono-Like Cast Silicon with Induced Grain Boundaries