Abstract:The calcination temperature effects on structural, magnetic, morphological, electrical, and dielectric properties for Mg 0.6 Co 0.2 Cu 0.2 FeCrO 4 spinel ferrites have been investigated in this work. The samples (abbreviated as S900 and S1100) were prepared by the sol-gel route and calcined at two different temperatures (900 °C and 1100 °C). The thermogravimetric analysis was used to investigate the weight loss versus temperature and the formation of the spinel phases. The cation distributions were estimated for the samples using experimental XRD patterns based on the Rietveld refinement of the atomic occupancy values. With increasing calcination temperature, unit cell parameters and average crystallite size show an increasing trend. From the magnetic hysteresis loops, low coercive fields were obtained, making Mg 0.6 Co 0.2 Cu 0.2 FeCrO 4 ferrites suitable candidates for soft magnetic devices. Nyquist-diagrams modeling shows that the conduction process in the samples is governed by the effect of grain and grain boundary contributions. Impedance and modulus curves show a dielectric relaxation phenomenon in the samples with non-Debye nature. The samples show electrical insulating (I)-semiconducting (S) transitions at T IS = 360 K for S900 and T IS = 400 K for S1100. Both NSPT and CBH models were used to explain the sample conduction process. Due to the increase in crystallite size with increasing calcination temperatures, activation energies decrease from 0.279 to 0.211 eV for S900 and S1100, respectively. In addition, the synthesized materials exhibit low dielectric constants and dielectric losses at higher frequencies as well as high electrical resistivity. These properties make Mg 0.6 Co 0.2 Cu 0.2 FeCrO 4 samples suitable candidates for high-frequency applications and microwave absorption devices.

Chemical State, Site, Solid Solubility, and Magnetism of Fe in the Ferropericlase (Mg 1– x Fe x )O Produced by Ball Milling of MgO and Fe

Complete substitution of Fe2+ by Mg in Fe4O5: The crystal structure of the Mg2Fe2O5 end-member

New Insights on Consolidation Behavior of Fe2O3 in the Fe3O4-CaO-MgO-SiO2 System for Fluxed Pellet Production: Phase Transformations and Morphology Evolution

Mechanical milling of Fe3O4/SiO2: Formation of an amorphous Fe(II)-Si-O-containing phase

Improved Magnetic and Electrical Properties of Zn Substituted Nanocrystalline MgFe2O4 Ferrite

Melting Behavior Of (Mg,Fe)O Solid Solutions At High Pressure

Systematic Study on the Synthesis and Magnetism Properties of Manganese Ferrite MnFe2O4 by an Oxidation Roasting Process

Synthesis of Mgfe2o4 Nanocrystallites under Mild Conditions

Preparation and Characterization of Nanocomposite MgFe2O4/SiO2

Formation Mechanism of MnxFe3 − Xo4 by Solid-State Reaction of MnO2 and Fe2O3 in Air Atmosphere: Morphologies and Properties Evolution

Structure and Magnetic Properties of MgFe2O4 Nanoparticles Prepared by the Low-Temperature Solid-State Reaction Method

Formation of 25 Mol% Fe2o3-Al2o3 Solid Solution by High-Energy Ball Milling

Facile Synthesis, Characterization and Dielectric Properties of Zn2+ Substituted MgFe2O4 Spinel Nanoparticles

Synthesis, Structural and Morphological Characterization, and Dielectrical Behavior of BaFeO3-x

Formation of 25 Mol % Fe<sub>2</sub>O<sub>3</sub>-Al<sub>2</sub>O<sub>3</sub> Solid Solution by High-Energy Ball Milling

Formation and Properties of BaxFe3−xO4 with Spinel Structure by Mechanochemical Reaction of Α-Fe2o3 and BaCO3

Sol–gel synthesis and characterization of magnesium ferrites by XRD, TEM, EPR, Mossbauer, and impedance spectroscopy

Structural, Magnetic, and Dielectric Properties for Mg0.6Co0.2Cu0.2FeCrO4 Spinel Ferrites Prepared Under Different Calcination Temperatures

Interface Diffusion and Reaction Mechanisms of Fe3O4–MgO System in Pellets under Different Atmospheres

Effect of FeO on the Formation of Spinel Phases and Chromium Distri- Bution in the CaO-SiO2-MgO-Al203-Cr203 System

Synthesis and Crystal Chemistry of Fe3+-bearing (mg,fe3+)(si,fe3+)o3 Perovskite