Abstract:Lithium-rich layered oxides have attracted much attention due to their high discharge capacity (>250 mA h·g–1). However, lithium-rich layered cathodes suffer from poor rate capabilities and voltage decay, which seriously limit their practical application. Herein, a unique @spinel double-spinel shell heterostructure is designed and successfully synthesized via coprecipitation and high-temperature solid-phase methods. In particular, lithium-rich layered oxides show good rate capabilities and high capacity retention when the molar amount of cobalt acetate and manganese acetate is 5%. After 100 cycles at 0.2 C, a discharge capacity of 232 mA h g–1 and a capacity retention of 92.7% can be obtained. The superior electrochemical performance of the in situ-transformed Li-rich layered cathode can be attributed to the unique three-dimensional diffusion channels for Li ions of the surface spinel phase. Besides, the in situ-transformed LiCoMnO4 shell can also improve the structural stability of the Li-rich layered oxides by reducing the side reactions and protecting the material from being corroded by the electrolyte. This study provides a strategy for surface modification, which can effectively improve the electrochemical performance of Li-rich layered cathode materials with high performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01955.SEM image of the precursor Ni1/6Co1/6Mn4/6CO3 and the corresponding mapping spectrum; ex situ XRD spectra of the LLO and LSS-0.05 samples; EDS line scan of the selected area and the corresponding HTEM diagram of the LSS-0.05 sample; CV and dQ/dV curves of the first three cycles of the LLO, LSS-0.05, and LSS-0.1 samples; initial charge and discharge curves of LiCoMnO4, LSS-0.2, and LSS-0.4 samples; discharge curves of LLO, LSS-0.05, and LSS-0.1 samples at different rates and with different cycles; typical single titration curve of GITT measurements; equivalent circuit of half-cells; and EIS spectra of LLO, LSS-0.05, and LSS-0.1 samples in the initial cycle (PDF)This article has not yet been cited by other publications.

Spinel/layered heterostructured cathode material for high-capacity and high-rate Li-ion batteries.

Ordered LiNi0.5Mn1.5O4 Cathode in Bis(fluorosulfonyl)imide-Based Ionic Liquid Electrolyte: Importance of the Cathode-Electrolyte Interphase

LiNi0.5Mn1.5O4 cathode microstructure for all-solid-state batteries

Spinel/Layered Heterostructured Lithium-Rich Oxide Nanowires as Cathode Material for High-Energy Lithium-Ion Batteries

An Li-rich oxide cathode material with mosaic spinel grain and a surface coating for high performance Li-ion batteries

Layer-spinel heterostructure 0.5NaMnO2-0.5Li0.5Mn2O4 cathode for advanced lithium ion batteries

Ultrathin 3 V Spinel Clothed Layered Lithium‐Rich Oxides as Heterostructured Cathode for High‐Energy and High‐Power Li‐ion Batteries †

In Situ Reconstruction of the Spinel Interface on a Li-Rich Layered Cathode Material with Enhanced Electrochemical Performances through HEPES and Heat Treatment Strategy

Boosting the Electrochemical Performance of a Spinel Cathode with the In Situ Transformed Allogenic Li-Rich Layered Phase

A Layered-Spinel Lithium Manganite Hydrate for High-Capacity and Ultrafast Lithium Storage

Lithium Manganese Spinel Cathodes for Lithium‐Ion Batteries

Simple and Ingenious Manner To Build Li-Rich Layered Materials with Surface Layered/Spinel Heterostructures and Li Deficiencies

Crystallographic‐Site‐Specific Structural Engineering Enables Extraordinary Electrochemical Performance of High‐Voltage LiNi 0.5 Mn 1.5 O 4 Spinel Cathodes for Lithium‐Ion Batteries

Performance Improvement of Li-rich Layer-Structured Li1.2Mn0.54Ni0.13Co0.13O2 by Integration with Spinel LiNi0.5Mn1.5O4

Engineering Hetero-Epitaxial Nanostructures with Aligned Li-ion Channels in Li-rich Layered Oxides for High-Performance Cathode Application

Improving the Electrochemical Performance of a Lithium-Rich Layered Cathode with an In Situ Transformed Layered@Spinel@Spinel Heterostructure

Enhanced long-term cyclability in Li-Rich layered oxides by electrochemically constructing a LixTM3-xO4-type spinel shell

Structure Evolution from Layered to Spinel during Synthetic Control and Cycling Process of Fe-Containing Li-Rich Cathode Materials for Lithium-Ion Batteries

Spinel LiNi0.5Mn1.5O4 shell enables Ni-rich layered oxide cathode with improved cycling stability and rate capability for high-energy lithium-ion batteries

Implication of Lithium Excess Induced Structure and Electrochemical Behavior Changes of LiNi 0.5 Mn 1.5 O 4 Spinel

An interfacial framework for breaking through the Li-ion transport barrier of Li-rich layered cathode materials