Abstract:Lithium-rich layered oxides have attracted much attention due to their high discharge capacity (>250 mA h·g–1). However, lithium-rich layered cathodes suffer from poor rate capabilities and voltage decay, which seriously limit their practical application. Herein, a unique @spinel double-spinel shell heterostructure is designed and successfully synthesized via coprecipitation and high-temperature solid-phase methods. In particular, lithium-rich layered oxides show good rate capabilities and high capacity retention when the molar amount of cobalt acetate and manganese acetate is 5%. After 100 cycles at 0.2 C, a discharge capacity of 232 mA h g–1 and a capacity retention of 92.7% can be obtained. The superior electrochemical performance of the in situ-transformed Li-rich layered cathode can be attributed to the unique three-dimensional diffusion channels for Li ions of the surface spinel phase. Besides, the in situ-transformed LiCoMnO4 shell can also improve the structural stability of the Li-rich layered oxides by reducing the side reactions and protecting the material from being corroded by the electrolyte. This study provides a strategy for surface modification, which can effectively improve the electrochemical performance of Li-rich layered cathode materials with high performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01955.SEM image of the precursor Ni1/6Co1/6Mn4/6CO3 and the corresponding mapping spectrum; ex situ XRD spectra of the LLO and LSS-0.05 samples; EDS line scan of the selected area and the corresponding HTEM diagram of the LSS-0.05 sample; CV and dQ/dV curves of the first three cycles of the LLO, LSS-0.05, and LSS-0.1 samples; initial charge and discharge curves of LiCoMnO4, LSS-0.2, and LSS-0.4 samples; discharge curves of LLO, LSS-0.05, and LSS-0.1 samples at different rates and with different cycles; typical single titration curve of GITT measurements; equivalent circuit of half-cells; and EIS spectra of LLO, LSS-0.05, and LSS-0.1 samples in the initial cycle (PDF)This article has not yet been cited by other publications.

Simple and Ingenious Manner To Build Li-Rich Layered Materials with Surface Layered/Spinel Heterostructures and Li Deficiencies

A Simple and Efficient Strategy to Construct Li-rich Layered Materials with Surface Layered/Spinel Heterostructures

Surface Modification and Electrochemical Properties of Li-Rich Layered Cathode Materials for Lithium-Ion Batteries

An In Situ Near‐Surface Reconstruction Strategy Endowing Lithium‐Rich Oxides with Li/O Dual Vacancies and Spinel‐Carbon Dual Coating Layers Toward High Energy Density Cathode

Improving the Electrochemical Performance of a Lithium-Rich Layered Cathode with an In Situ Transformed Layered@Spinel@Spinel Heterostructure

Enhanced Electrochemical Performance of Layered Lithium-Rich Cathode Materials by Constructing Spinel-Structure Skin and Ferric Oxide Islands.

Facilitating structural stability of the Li-rich layered cathode materials by cation rearrangements and Li vacancies

Dual Conductive Surface Engineering of Li-Rich Oxides Cathode for Superior High-Energy-density Li-Ion Batteries

Suppressing Bulk Strain and Surface O2 Release in Li-Rich Cathodes by Just Tuning the Li Content

In Situ Reconstruction of the Spinel Interface on a Li-Rich Layered Cathode Material with Enhanced Electrochemical Performances through HEPES and Heat Treatment Strategy

Synergistic Enhancement of Li-rich Manganese-based Cathode Materials through Single Crystallization and In-situ Spinel Coating

Boosting the Electrochemical Performance of a Spinel Cathode with the In Situ Transformed Allogenic Li-Rich Layered Phase

Interfacial-engineering-enabled High-Performance Li-rich Cathodes

Alternate heterogeneous superlattice control of lattice strain to stabilize Li-rich cathode

The superior electrochemical performance of a Li-rich layered cathode material with Li-rich spinel Li<sub>4</sub>Mn<sub>5</sub>O<sub>12</sub> and MgF<sub>2</sub> double surface modifications

Mitigating Evolution of Lattice Oxygen and Stabilizing Structure of Lithium-Rich Oxides by Fabricating Surface Oxygen Defects

Structural Insights into Lithium-Deficient Type Li-rich Layered Oxide for High-Performance Cathode

Enhanced long-term cyclability in Li-Rich layered oxides by electrochemically constructing a LixTM3-xO4-type spinel shell

Enhancing Ionic Transport and Structural Stability of Lithium‐Rich Layered Oxide Cathodes via Local Structure Regulation

Improved Electrochemical Performance of Li-Rich Cathode Materials via Spinel Li2MoO4 Coating

Surface spinel reconstruction to suppress detrimental phase transition for stable LiNi0.8Co0.1Mn0.1O2 cathodes