Abstract:TiO2-diatomite photocatalysts were prepared by sol-gel process with various pre-modified diatomite. In order to obtain diatomite with different surface characteristics, two modification approaches including calcination and phosphoric acid treatment on the micro-structure of diatomite are introduced. The photocatalysts were characterized by XRD, XPS, nitrogen adsorption-desorption isotherms and micromorphology analysis. The results indicate that, compared with pure TiO2, the anatase-to-rutile phase transition temperature of TiO2 loaded on diatomite carrier is significantly increased to nearly 900 degrees C, depending on the different pretreatment method of diatomite. The photocatalytic activities of different samples were evaluated by their degradation rate of methyl orange ( MO) dye under UV and visible-light irradiation. The samples prepared by phosphoric acid pretreatment method exhibit the highest photocatalytic activity. After 90 min of UV irradiation, about 90% of MO is decomposed by the best effective photocatalyst. And after 8 h visible-light irradiation, nearly 60% of MO is decomposed by the same sample. Further mechanism investigation reveals that the H3PO4 pretreatment process can obviously change the surface features of diatomite carrier, cause the formation of Si-O-Ti bond, increase the binding strength between TiO2 and diatomite, restrain crystal growth of loaded TiO2, and thus form thermal-stable meso-porous structure at the granular spaces. It helps to build micro-, meso- and macro-porous hierarchical porous structure in TiO2-diatomite, and improves the charge and mass transfer efficiency during catalyzing process, resulting in the significantly increased photocatalytic activity of TiO2-diatomite pretreated by phosphoric acid. (C) 2014 Elsevier B. V. All rights reserved.

Preparation of Titanium Dioxide Porous Thin Films Via Photopolymerization of the Colloidal TiO2 Dispersion

Controllable Hydrothermal Synthesis, Optical and Photocatalytic Properties of TiO2 Nanostructures

Controllable Fabrication and Characterization of Porous C/TiO2 Nanocomposite Films As Solar Selective Absorber

Interface Actions Between TiO2 and Porous Diatomite on the Structure and Photocatalytic Activity of TiO2-diatomite

Fabrication Of Macroporous Titanium Dioxide Film Using Pmma Microspheres As Template

A Preparation Method To Obtain Porous Anatase Tio2 Films At Room Temperature

Fabrication and Photocatalytic Properties of Porous Crystalline Titanium Dioxide Film Co-Doped with Fe and Si by PEO

Porous titania films prepared from interactions of titanium with hydrogen peroxide solution

Preparation and characterization of porous carbon–titania nanocomposite films as solar selective absorbers

Low-Temperature Preparation of Macroporous Anatase TiO2 Thin Film and Its Photocatalytic Activity

A Facile Method of Preparing Sandwich Layered TiO2 in Between Montmorillonite Sheets and Its Enhanced UV-light Photocatalytic Activity

Preparation of Macroporous and Mesoporous Tio2 Film with Various Solvents

Solvothermal synthesis of stable nanoporous polymeric bases-crystalline TiO2 nanocomposites: visible light active and efficient photocatalysts for water treatment.

Influence of Factors on Porous TiO_2 Films Prepared at Room Temperature

Room-temperature preparation and formation mechanism of porous anatase TiO2 film

Fabrication of Porous Tio2 Film Via Hydrothermal Method and Its Photocatalytic Performances

Hydrothermal Preparation Of Nanoporous Tio2 Films With Exposed {001} Facets And Superior Photocatalytic Activity

Low-temperature fabrication of porous anatase TiO2 film with tiny slots and its photocatalytic activity

Preparation and Characterization of Hierarchically Porous Monolithic TiO2

Synthesis of TiO2 Porous Thin Films by Polyethylene Glycol Templating and Chemistry of the Process

Preparation of Porous Anatase Titania Film