Abstract:A long standing and very challenging problem is to predict the ultimate strength of a fibrous laminate under arbitrary load condition only based on the mechanical properties of its constituents measured independently. Although the Bridging Model is unique for calculating the internal stresses in the constituent fiber and resin (which stands for a matrix material throughout this paper) materials subjected to any load including a temperature variation, the in situ mechanical properties of the constituents must be provided beforehand. A unidirectional (UD) composite exhibits a transverse tensile strength smaller than the tensile strength of the monolithic resin material, indicating that the in situ tensile strength of the resin in the transverse direction is different from that measured using monolithic material specimens. This is attributed to a stress concentration. The stress concentration factors (SCFs) of the resin material in a RVE (representative volume element) due to occurrence of the fiber are determined in terms of elasticity theory. The resin in situ tensile, compressive, and shear strengths in the transverse plane are obtained by the corresponding resin strengths measured independently divided by the respective SCFs, whereas the resin in situ longitudinal strengths together with all the other constituent properties are the same as their original counterparts. Using these originally provided constituent properties as input data, the Bridging Model has been applied to analyze the second World-Wide Failure Exercise (WWFE-II) problems. The model's predictions for all the problems have been compared with available experimental data. Favorable correlation has been found.

Stress Concentration Factor in the Matrix Reinforced with Fiber Having an Interface Layer

Stress Concentration Factors in the Matrix with Different Imperfect Interfaces

Stress Concentration Factor in Matrix of A Composite Reinforced with Transversely Isotropic Fibers

On Stress Concentration Factors Of Matrix In A Composite

Constitutive Relation, Deformation, Failure and Strength of Composites Reinforced with Continuous/short Fibers or Particles

Keynote: Stress Concentration Factors of Matrix in a Composite Subjected to Transverse Loads

Predicting strength of fibrous laminates under triaxial loads only upon independently measured constituent properties

Simulation Of Ultimate Strength Of Fiber-Reinforced Composites By Means Of Bridging Micromechanics Model

Stress Concentration Factors Of Matrix In Composite Under Transverse Loads

Effect of Multiple Matrix Cracking on Crack Bridging of Fiber Reinforced Engineered Cementitious Composite

Micromechanical Analysis Of Nonlinear Response On Fibrous Composite

Bridging tensor with an imperfect interface

Prediction of overall tension behavior of short fiber-reinforced composites

Stiffness Prediction of Short Fiber Reinforced Composites

The Fiber-Matrix Interfacial Stress on and Beneath the Surface of Long-Fiber-Reinforced Composites

Micromechanical approach to the elastoplastic behavior of a fiber reinforced composite

Stress Concentration Factor in Matrix of a Composite Subjected to Transverse Compression

A New Approach to A Bridging Tensor

Predicting Strength of a Unidirectional Composite Containing Interface Crack

Effect of Matrix Plasticity on Ultimate Strength of Composite Laminates

Simulation of the mechanical properties of fibrous composites by the bridging micromechanics model