Abstract:This research represents an exploratory characterization of titanium alloy strips under electroplastic rolling process compared with cold-rolling process. The formability, mechanical property and microstructure evolution of the titanium alloy strips under these two rolling processes are conducted in the research. Results show that the shaping quality of electroplastic rolled samples is better than that of cold-rolled samples without obvious deformed defects accompanying by lower resistance of deformability (the reduction can reach 31.25%). The final electroplastic rolled products obtain better comprehensive mechanical property with at most 248.5% increment of ductility while sacrificing little strength. In the low-frequency process, dynamic recovery and dynamic recrystallization appear with decreasing average size of grains and increasing volume fraction of recrystallized grains. In the high-frequency process, grain coarsening and uneven growth are both present The evolution of texture (including basal texture and < 10 (1) over bar0 > crystal orientation) and misorientation angle distribution explain the materials' ductility change. Fracture observation also demonstrates this change with transitional fracture modes. The mechanism of rapid dynamic reaystallization and abnormal grain growth under hybrid effects of high-energy electropulses effect and deformation energy is discussed. (C) 2014 Elsevier Inc. All rights reserved.

Effect of Electroplastic Rolling on the Ductility and Superelasticity of Tini Shape Memory Alloy

Effect of Electroplastic Rolling on Deformability and Oxidation of NiTiNb Shape Memory Alloy

RETRACTED: Effect of Electroplastic Rolling on Deformability, Mechanical Property and Microstructure Evolution of Ti–6Al–4V Alloy Strip

The Improved Plasticity of NiTi Alloy Via Electropulsing in Rolling

The Improved Superelasticity of NiTi Alloy Via Electropulsing Treatment for Minutes

Transformation Behaviors and Superelasticity of Ti 50 Ni 48 Fe 2 Shape Memory Alloy Subjected to Cold-Rolling and Subsequent Annealing

Effect of Electropulsing Treatment on the Microstructure and Superelasticity of TiNi Alloy

Enhancement of Ductility, Weakening of Anisotropy Behavior and Local Recrystallization in Cold-Rolled Ti-6Al-4V Alloy Strips by High-Density Electropulsing Treatment

Superplastic Deformation Behaviors and Power Dissipation Rate for Fine-Grained Ti-6Al-4V Titanium Alloy Processed by Direct Rolling

Effects of Strain and Electropulse Duration on Elastic Modulus of TiNi Alloy

Effect of Strain Rate on Microstructure and Mechanical Properties of Electroplastic Rolled ZrTi Alloy

Effect of Direct Rolling Process on Microstructure and Mechanical Properties of the Electron Beam Cold Hearth Melting Ti-6Al-4V Alloy

Effect of Cold Rolling and Hot Rolling on Recrystallization Texture and Superelastic Properties of Ti–30Zr–10Nb–2Sn Shape Memory Alloy

The Influence of Electroplastic Rolling on the Mechanical Deformation and Phase Evolution of Bi-2223/Ag Tapes

Effect of pack rolling on microstructures and tensile properties of as-forged Ti-44Al-6V-3Nb-0.3Y alloy

Effect of plasticity on superelasticity and hysteretic dissipation of NiTi shape memory alloy

Effects of Ecae and Aging on Phase Transformations and Superelasticity of A Ni-Rich Tini Sma

Effect of Recovering Damage and Improving Microstructure in the Titanium Alloy Strip under High-Energy Electropulses

Cryogenic Rolling Induces Quasi-Linear Superelasticity with High Strength over a Wide Temperature Range in TiNi Shape Memory Alloys

Combined Effect of Annealing Temperature and Pre-deformation on the Superelastic Behaviors of NiTi Shape Memory Alloys

Electroplastic Rolling of 304 Stainless Steel Strip