Microstructure of Gear Steels Treated by Shot Peening by X-Ray Line Profile Analysis Method
Pengfei Zhu,Hongzhi Yan,Jibo Zhou,Youliang Zhou,Yin Zhang,Zhi Chen
DOI: https://doi.org/10.1007/s12540-023-01436-4
IF: 3.451
2023-01-01
Metals and Materials International
Abstract:Shot peening is a common surface strengthening process of gears. It can induce compressive residual stress, refine grain size and increase dislocation density. However, there are limited reports on the quantitative analysis of dislocation substructures (type, fraction and arrangement), crystallite size and micro-strain in different crystal planes. To further reveal the microstructure strengthening mechanism of gears during shot peening, X-ray diffraction line profile analysis (XRDLPA) method is applied to study the effect of coverage on the microstructure of the gear steels. The results show that with increasing coverage, the dislocation density is increased from 2.62 × 1016 to 3.37 × 1016 m−2 in the form of screw-edge-mixed type as determined from the dislocation characteristic parameter q. The fraction of edge dislocation increases, whereas the fraction of screw dislocation decreases. The dislocation arrangement parameter M is decreased from 7.1 to 5.6, indicating that the formation of dislocation dipoles or dislocation cells in the surface layer can be further enhanced by increasing coverage. Due to the different degrees of atomic slip, the (200) crystallographic plane exhibits the smallest crystallite size and highest micro-strain, whereas the (222) plane shows the smallest micro-strain and the largest crystallite size. In addition, during shot peening, the enhancement of surface hardness of the gear steels is attributed to the phase transformation strengthening, grain-boundary hardening and dislocation hardening. The surface compressive stress of the gear steels induced by shot peening is affected not only by phase transformation, but also by Bauschinger effect, surface topography, grain refinement and so on.