Abstract:The strive to achieve increasingly higher efficiencies in gas turbine power generation has led to a continued rise in the turbine inlet temperature. As a result, novel cooling approaches for gas turbine blades are necessary to maintain them within the material's thermal mechanical performance envelope. Various internal and external cooling technologies are used in different parts' of the blade airfoil to provide the desired levels of cooling. Among the different regions of the blade profile, the trailing edge (TE) presents additional cooling challenges due to the thin cross section and high thermal loads. In this study, a new wavy geometry for the TE has been proposed and analyzed using steady state numerical simulations. The wavy TE structure resembled a sinusoidal wave running along the span of the blade. The troughs on both pressure side and suction side contained the coolant exit slots. As a result, consecutive coolant exit slots provided an alternating discharge between the suction side and the pressure side of the blade. Steady state conjugate heat transfer simulations were carried out using CFX solver for four coolant to mainstream mass flow ratios of 0.45%, 1%, 1.5% and 3%. The temperature distribution and film cooling effectiveness in the TE region were compared to two conventional geometries, pressure side cutback and centerline ejection which are widely used in vanes and blades for both land-based and aviation gas turbine engines. Unstructured mesh was generated for both fluid and solid domains and interfaces were defined between the two domains. For turbulence closer, SST-k omega model was used. The wall y+ was maintained < 1 by using inflation layers at all the solid fluid interfaces. The numerical results depicted that the alternating discharge from the wavy TE was able to form protective film coverage on both the pressure and suction side of the blade. As a result, significant reduction in the TE metal was observed which was up to 14% lower in volume averaged temperature in the TE region when compared to the two baseline conventional configurations.

Experimental Investigation on Cooling Performance of Binary Cooling Gas Turbine Vane

Transpiration Cooling of High Pressure Turbine Vane with Optimized Porosity Distribution

Multi-objective Optimization of Transpiration Cooling for High Pressure Turbine Vane

An Experimental Study of Turbine Vane Film Cooling Using Endoscope-Based PSP Technique in a Single-Passage Wind Tunnel

An Experimental Research on the Cooling Performance of the Turbine Vane with an Advanced Duplex-Medium Combined Cooling

Experimental Study on Comparison of Cooling Effectiveness Between Steam and Air for a Gas Turbine Nozzle Guide Vane

Research on heavy-duty gas turbine vane high efficiency cooling performance considering coolant phase transfer

Numerical Investigation on Compound Cooling Effect of High Temperature Vane with TBC

Experimental investigation on the combined cooling methods of jet impingement and film cooling for the pressure surface of the turbine vane leading cavity

Cooling Methods for Gas Turbine Blade Leading Edge: Comparative Study on Impingement Cooling, Vortex Cooling and Double Vortex Cooling

NUMERICAL STUDY OF SLOT FILM COOLING PERFORMANCE AT THE TRAILING EDGE OF A TURBINE VANE

Investigation of the Steam-Cooled Blade in a Steam Turbine Cascade

Experimental Investigation of Cooling Performance of Air-Cooled Turbine Blade in a High-Temperature Wind Tunnel

Numerical Simulation for Heat Transfer Properties at Trailing Edge of Gas Turbine Airfoils

Numerical Study Of Heat Transfer In Novel Wavy Trailing Edge Design For Gas Turbine Airfoils

Conjugate Heat Transfer Investigation on Swirl-Film Cooling at the Leading Edge of a Gas Turbine Vane

A conjugate heat transfer investigation of outer-wall cooling performance in double-wall vane pressure side

Experimental study on cooling performance of a steam-cooled turbine blade with five internal cooling smooth channels

Coupled Aerothermodynamics Optimization for the Cooling System of a Turbine Vane

Experimental and numerical investigations on film cooling characteristics and hole shape improvement of turbine vane at one engine inoperative condition

HEAT TRANSFER ENHANCEMENT FOR GAS TURBINE BLADE LEADING EDGE COOLING USING CURVED DOUBLE-WALL/VORTEX COOLING WITH VARIOUS DISTURBING OBJECTS