Abstract:Internal steam cooling used in the vane can not only reduce the consumption of high-pressure air but also improve the overall turbine cycle efficiency. The present paper presents a research on a turbine vane with complicated cooling structure. The vane was cooled by a combination of steam and air, which was achieved by (1) cooling the leading edge with four rows of cooling air film holes; (2) cooling the middle chord area with two internal cooling steam ribbed channels; (3) cooling the trailing edge with a row of cooling air jet holes. The temperature and the static pressure were measured by the thermocouples and pressure taps located on the vane middle section. The coolant temperature and the coolant flow were then adjusted to obtain the cooling effectiveness to assess the vane cooling performance in different cooling conditions. The results of this study confirm that (1) when the test vane is applied to the advanced duplex-medium combined cooling, surface temperature can be even, accompanied with a small thermal stress as well as a high cooling effectiveness (the average cooling effectiveness was over 0.68), which implies that a satisfactory cooling performance has been achieved; (2) film cooling used at the leading edge can shift the stagnation point downstream and produce some flow losses, which, however, does not significantly affect the entire flow field of the vane passages; (3) the best cooling effect on the vane surface is in the middle chord area with internal steam cooling and its worst is on the pressure side near the trailing edge; (4) in improving cooling performance, increasing the steam flow rate is the most effective, enhancing the coolant pressure the next, and lowering the coolant temperature the least; (5) in lowering the overall vane surface temperature, lowering the coolant temperature is the most effective, increasing the steam flow rate the next, and enhancing the coolant pressure the least.

Research on heavy-duty gas turbine vane high efficiency cooling performance considering coolant phase transfer

Transpiration Cooling of High Pressure Turbine Vane with Optimized Porosity Distribution

Multi-objective Optimization of Transpiration Cooling for High Pressure Turbine Vane

Conjugate heat transfer simulation of turbine blade high efficiency cooling method with mist injection

Numerical Investigation On The Cooling Effectiveness Among Air And Steam And Mist/Steam For A Gas Turbine Vane

Conjugate heat transfer analysis of leading edge and downstream mist–air film cooling on turbine vane

Blade Cooling Technology of Heavy-duty Gas Turbines

An Experimental Research on the Cooling Performance of the Turbine Vane with an Advanced Duplex-Medium Combined Cooling

Conjugate Heat Transfer Investigation on Swirl-Film Cooling at the Leading Edge of a Gas Turbine Vane

Experimental investigation on the combined cooling methods of jet impingement and film cooling for the pressure surface of the turbine vane leading cavity

Numerical Study on Flow and Heat Transfer of a Cooled First Stage Vane of a Gas Turbine

Experimental Investigation on Cooling Performance of Binary Cooling Gas Turbine Vane

Structure Improvement on Turbine Guided Vane Cooling System Based on Conjugate Heat Transfer

Experimental Study on Comparison of Cooling Effectiveness Between Steam and Air for a Gas Turbine Nozzle Guide Vane

Data-Driven Conjugate Heat Transfer Analysis of a Gas Turbine Vane

Experimental and numerical investigations on film cooling characteristics and hole shape improvement of turbine vane at one engine inoperative condition

Accurate predictions of mist assisted film cooling characteristics and effectiveness on a flat plate with double-row holes

Heat Transfer Experimental Investigation of Mist/Steam or Steam Within Gas Turbine Blade Internal Cooling Passage

HEAT TRANSFER ENHANCEMENT FOR GAS TURBINE BLADE LEADING EDGE COOLING USING CURVED DOUBLE-WALL/VORTEX COOLING WITH VARIOUS DISTURBING OBJECTS

Measurements of Heat Transfer Coefficient and Film Cooling Effectiveness Distribution on a Vane Using Transient Liquid Crystal Technique

AN EXPERIMENTAL INVESTIGATION OF FULL-COVERAGE FILM COOLING CHARACTERISTICS OF A TURBINE GUIDE VANE