Numerical Simulation for Heat Transfer Properties at Trailing Edge of Gas Turbine Airfoils

Zhou Chao,Chang Haiping,Cui Deping,Mao Junkui

DOI: https://doi.org/10.3969/j.issn.1005-2615.2006.05.011

2006-01-01

Abstract:Numerical methods are used to investigate the film cooling effect of turbine guide vane′s trailing edge.The flow distribution in the vicinity of the trailing edge slot and the temperature of the trailing edge cut-back are studied.The influence factors of pressure side lip thickness H,pressure side angle θ,the width between the pressure and the suction sides,and blowing ratio are discussed when the inject angle of coolant gas is 0°.Results show that:(1)the coolant flow of the trailing edge slot first is separated from the trailing edge cut-back,then reattaches it again.Correspondingly, the temperature of the trailing edge cut-back first rises up then goes down,the highest temperature locals at about 5H downstream of the trailing edge slot;(2)at a certain mass flow rate,the thickness of the pressure side lip and the distance between two lips are two important factors.The thinner lip and the smaller distance lead to better film cooling effect,and the film cooling effect is not sensitive to the pressure side angle θ;(3)when the blowing ratio rises,the film cooling effect is enhanced.