Abstract:When considering methods of combating the illicit circulation of nuclear materials, it is necessary to detect trace amounts of materials, and in many cases not to seize them immediately, but to establish the place of storage, processing, routes of movement, etc. As a result, there is a new demand for isotope identification measurements to meet a wide range of different requirements. Measurements should be carried out in the field in a short time, when results need to be obtained within tens of seconds. The devices with which the personnel work should be small and low-background. Such requirements appear when working to identify cases of illegal trade in nuclear materials and radioactive sources, as well as when solving radiation protection problems and when handling radioactive devices and waste. In this work, new generation radiation sensors and measuring systems based on them have been created, which open up previously unknown possibilities in solving problems of nuclear fuel analysis, increasing the accuracy and efficiency of monitoring technological parameters and the state of protective barriers in nuclear power plants, and creating means for IAEA inspections. For the first time a portable digital gamma-ray spectrometer for radiation reconnaissance in the field was developed and created. Distinctive features of such devices are: The analysis showed that the required value of error due to energy dependence of the sensitivity can be achieved using, for example, Analog Devices 10-bit AD9411 ADCs with a sampling rate of 170 MHz. The number of quantization levels is determined by the requirement to measure the dose rate of gamma radiation with an energy of at least 10 keV. This minimum energy corresponds to the use of 10-bit ADCs. On the basis of the developed model, an ionizing radiation detector for dosimetry was created. Its fundamental difference from known devices is the use of CdZnTe crystals as a primary gamma-ray converter (sensor). The advantages of such a solution, proved by previous studies, made it possible to create a detector with: high resolution, no more than 40 keV; a wider dynamic range of values of the recorded radiation dose rate - from background to emergency operating modes of the reactor; lower value of the energy equivalent of noise.

Development of Non-contact On-line Nuclear Densimeter

Design Realization and Characterization of A Position Sensitive Detector for Fast Optical Measurement

Development of a light-weight portable neutron survey meter

Development of the Portable Ion Implanted Semiconductor Nuclear Radiation Meter

Design of Radiation Inspection System Based on Ionizing Radiation Detector

A Novel Compact Real Time Radiation Detector.

Development of a silicon carbide radiation detection system and experimentation of the system performance

Development of active environmental and personal neutron dosemeters

Design and Initial Tests of a Fast Neutron Radiography Detector Prototype with Silicon Photomultiplier Readouts

Development of a compact active neutron monitor to measure the H*(10): Design, Simulation and Validation

Research on Digital Nuclear Power Measurement Equipment

Compact Back-End Electronics with Temperature Compensation and Efficient Data Management for In Situ SiPM-Based Radiation Detection

RESEARCH PROCESSES OF GAMMA RADIATION DETECTOR FOR DEVELOPING A PORTABLE DIGITAL SPECTROMETER

Development of Large Area Silicon Semiconductor Detectors for Use in the Current Mode

Design of Solid-State Detector Modules for High Energy X-ray Imaging

Development of the Data Acquisition System for Photoneutron Imaging

Development of Front-End Readout Electronics for Silicon Strip Detectors

Development of Portable Partial Discharge On-line Monitoring System

Development of On-Line Measuring Device of Magnetic Particle Content

RAD01: Development of a NUMTEK RAD01 Low-Cost, Portable Digital Gamma Radiation Detector

Development of a Clyc-Based Wide Dose Rate Range Portable Neutron-Gamma Detector