Abstract:When considering methods of combating the illicit circulation of nuclear materials, it is necessary to detect trace amounts of materials, and in many cases not to seize them immediately, but to establish the place of storage, processing, routes of movement, etc. As a result, there is a new demand for isotope identification measurements to meet a wide range of different requirements. Measurements should be carried out in the field in a short time, when results need to be obtained within tens of seconds. The devices with which the personnel work should be small and low-background. Such requirements appear when working to identify cases of illegal trade in nuclear materials and radioactive sources, as well as when solving radiation protection problems and when handling radioactive devices and waste. In this work, new generation radiation sensors and measuring systems based on them have been created, which open up previously unknown possibilities in solving problems of nuclear fuel analysis, increasing the accuracy and efficiency of monitoring technological parameters and the state of protective barriers in nuclear power plants, and creating means for IAEA inspections. For the first time a portable digital gamma-ray spectrometer for radiation reconnaissance in the field was developed and created. Distinctive features of such devices are: The analysis showed that the required value of error due to energy dependence of the sensitivity can be achieved using, for example, Analog Devices 10-bit AD9411 ADCs with a sampling rate of 170 MHz. The number of quantization levels is determined by the requirement to measure the dose rate of gamma radiation with an energy of at least 10 keV. This minimum energy corresponds to the use of 10-bit ADCs. On the basis of the developed model, an ionizing radiation detector for dosimetry was created. Its fundamental difference from known devices is the use of CdZnTe crystals as a primary gamma-ray converter (sensor). The advantages of such a solution, proved by previous studies, made it possible to create a detector with: high resolution, no more than 40 keV; a wider dynamic range of values of the recorded radiation dose rate - from background to emergency operating modes of the reactor; lower value of the energy equivalent of noise.

Development of the Portable Ion Implanted Semiconductor Nuclear Radiation Meter

Development of a light-weight portable neutron survey meter

Design of Radiation Inspection System Based on Ionizing Radiation Detector

RESEARCH PROCESSES OF GAMMA RADIATION DETECTOR FOR DEVELOPING A PORTABLE DIGITAL SPECTROMETER

Development of a silicon carbide radiation detection system and experimentation of the system performance

Development of a high energy resolution and wide dose rate range portable gamma-ray spectrometer

RAD01: Development of a NUMTEK RAD01 Low-Cost, Portable Digital Gamma Radiation Detector

Studies on Radioluminescence Dose-Rate Measurement Based on LiF:Mg,Ti and SiPM

Low-cost wireless smart device design for radiation protection and nuclear security

Measurement and Simulation of Ultra-Low-Energy Ion-Solid Interaction Dynamics

Development of a compact active neutron monitor to measure the H*(10): Design, Simulation and Validation

Development of Large Area Silicon Semiconductor Detectors for Use in the Current Mode

DEVELOPMENT OF A PORTABLE GAMMA PROBE FOR REGISTRATION AND LOCALIZATION OF RADIATION SOURCE, INCLUDING MEDICAL APPLICATION

Development of active environmental and personal neutron dosemeters

Development of a portable gas-filled ionization chamber

Flexible Single Microwire X‐Ray Detector with Ultrahigh Sensitivity for Portable Radiation Detection System

Development and application of emannometer of scintillation detector

Progress in the Development of Silion Photomultipliers Electrophotonic Detector Based on Nuclear Medicine Imaging

Development and Evaluation of A Ccd-Based Portable Digital Flash X-Ray Imager

Design and Development Of Scintillation – Based Gamma Dosimeter Using SIPM Detector

Latest developments in room-temperature semiconductor neutron detectors: Prospects and challenges