Abstract:Science Progress, Volume 107, Issue 3, July-September 2024. Accurately measuring the mechanical properties of high-strength stainless steels is of great significance for ensuring structural safety, predicting long-term performance and optimizing design. However, the standardized tensile test specimens used to obtain strength properties must be fabricated from bulk materials from an in-service structure or component, result in the loss of structural integrity or a reduction in remaining service life. Small punch tests require only miniscule material samples and are widely used to estimate in-service component material characteristics. This study performed small punch tests on three high-strength stainless steels—X17CrNi15-2, 15-5PH, and PH13-8Mo—to obtain the correlations between the small punch tests and the uniaxial tensile test results for each material. The estimated yield stresses obtained from the small punch tests were distributed within a factor of 1.5 on both sides of the unity line when compared with those obtained from the uniaxial tensile tests; the ultimate strength values estimated from the small punch tests correlated quite well with those obtained from the uniaxial tensile tests. An iterative finite element analysis was subsequently established to simulate the small punch tests and thereby obtain the coefficients for a Ludwik power law correlation representing the true stress–strain properties. The finite element predicted force–deflection curves agreed well with the small punch test results, which were also compared with the predictions obtained from empirical equations proposed in previous studies. Finally, the fracture mechanisms of the small punch test specimens were characterized through scanning electron microscopy, indicating that the dimple fracture mechanism dominated the failure mode. The results of this study are expected to inform the application of small punch test to evaluate in-service high-strength stainless steel materials.

Small Punch Test of U-Shaped Notch of Tc4 Titanium Alloy and Its Numerical Simulation

Small Punch Testing of a Ti6Al4V Titanium Alloy and Simulations under Different Stress Triaxialities

Finite Element Analysis of Small Punch Test for Ti Matrix Composites

Ductile Fracture of Titanium Alloys in the Dynamic Punch Test

Mechanical Behaviour and Strain Rate Sensitivity Analysis of TA2 by the Small Punch Test

An Investigation of Small-crack and Long-crack Propagation Behavior in Titanium Alloy TC4 and Aluminum Alloy 7475-T7351

Study of estimation of ductile-brittle transition temperature using U-notched small punch test specimens

Assessment of Fracture Toughness Using Small Punch Tests of Prenotched Specimens

Mechanical Properties Study of Miniature Steel Specimens Based on the Small Punch Test and Simulation Methods

Effect of Notch on the High and Low Cycles Fatigue of TC21 Alloy

Notch fatigue behavior of a titanium alloy in the VHCF regime based on a vibration fatigue test

Effects of notch width and loading rate on the dynamic mode II fracture toughness of Ti-6Al-4V

Evaluating the tensile properties of high-strength stainless steels using small punch testing

Stress Distribution Calculation of Notched Fatigue Specimens of TC21 Alloy

Fatigue property and failure mechanism of TC4 titanium alloy in the HCF and VHCF region considering different forging processes

Prediction of Fatigue Life of TC4 Titanium Alloy Based on Normalized Equivalent Initial Flaw Size Model

Interaction Between Local Plastic Strain and Multi-Scale Fatigue Crack Propagation Behavior in Titanium Alloy TC4

A Novel Ultrasonic Fatigue Test and Application in Bending Fatigue of TC4 Titanium Alloy

Experimental Study on Forged TC4 Titanium Alloy Fatigue Properties under Three-Point Bending and Life Prediction

Influence of notch root radius on high cycle fatigue properties and fatigue crack initiation behavior of Ti-55531 alloy with a multilevel lamellar microstructure

Study on Influence Factors of Small Punch Test Based on Ductile Damage Numerical Analysis