Abstract:This paper addresses the acoustic and aerodynamic characteristics of small rotor configurations, including the influence of the rotor–rotor interactions. For this purpose, a Rotor/Rotor/Pylon configuration is chosen for both the test and numerical simulations. The wind tunnel experiments on various rotor configuration were performed in DLR's Acoustic Wind Tunnel Braunschweig (AWB). The experiments involve isolated rotors, and rotors in tandem and coaxial configuration in hover and forward flight. For numerical simulations, an unsteady free wake 3D panel method (UPM) is used to account for aerodynamic non-linear effects associated with the mutual interference among the Rotor/Rotor/Pylon configurations. The effect of the pylon is simulated using potential theory in form of a panelized body. Finally, the sound propagation into the far field is calculated with DLR's FW–H code APSIM, using UPM blade surface pressure as input. The validation effort is supported by CFD TAU steady simulations on selected hover test cases. The experiments and numerical results indicate that the noise at the blade passing frequency (BPF) and its higher harmonics is the dominant source of the noise for the present rotor selection. The extra subharmonics between two BPFs appearing in the results are caused by the small geometric discrepancy between the blades as well as the motor noise. Broadband noise is also observed in the experiment, but its contribution to the overall sound pressure is very small and can be neglected. The simulation of the acoustic scattering from the rotor support system for the isolated rotor cases indicated an influence about 1–3 dB on the overall sound pressure of the polar microphones. In both the coaxial and the tandem configuration, the acoustic interferences are particularly well visible in the numerical simulations and cause a more complex noise directivity. There is almost no change in time-averaged inflow by applying phase angles. In the coaxial condition, in hover, the phase delay between rotors does not change the maximum noise level. In forward flight, the phase delay can influence the maximum level of the noise radiation. In both coaxial and tandem configuration, the position of the downstream rotor is key for the noise radiation, and therefore, avoiding the interaction with upstream wake can reduce the noise radiation.

Aeroacoustics Benefit of Stator Lean Effect for Rotor-Stator Interactions

NUMERICAL INVESTIGATION OF STATOR CLOCKING EFFECTS ON THE DOWNSTREAM STATOR IN A 1.5-STAGE AXIAL TURBINE

Influence of Blade Lean Together with Blade Clocking on the Overall Aerodynamic Performance of a Multi-Stage Turbine

Multi-Objective Design Optimization of a Transonic Compressor Rotor Using an Adjoint Equation Method

Stator modification methods for diagonal flow fans to achieve noise reduction of rotor-stator interaction

Multipoint Design Optimization of a Transonic Compressor Blade by Using an Adjoint Method

Design Optimization of the Last Stage of a 4.5-Stage Compressor Using a POD-based Hybrid Model

Optimization of cantilevered stators in an industrial multistage compressor to improve efficiency

Smart Blade Count Selection to Align Modal Propagation Angle with Stator Stagger Angle for Low-Noise Ducted Fan Designs

Numerical Investigation of the Superimposed Effects on Stator Wake Oscillation in an Axial-Radial Combined Compressor

Unsteady rotor force suppression of a pump-jet by stator actuated oscillating trailing edge flaps: A numerical study

Aerodynamic Design and Performance Analysis of a Vaneless Counter-Rotating Fan and Compressor

Influence of Rotor-Stator Axial Clearance on Compressor Rotating Stall Characteristics

Aerodynamic performance improvement of a transonic compressor rotor with a small plate near the leading edge

Influence of trailing edge radius of intake struts on excitation force and vibration of rotor blades

Numerical Investigation on the Effects of Airfoil Leading Edge Radius on the Aerodynamic Performance of H-Rotor Darrieus Vertical Axis Wind Turbine

Unsteady Pressure Behavior on Blade Surface Induced by Wake-Blade Interaction in an Axial Compressor Stage

Effect of asymmetric leading edge on transition of suction side

Numerical studies on small rotor configurations with validation using acoustic wind tunnel data

Numerical Research On Effects Of Shroud Contraction On Tip Leakage Flow And Overall Performance Of Axial Compressors

Numerical study of acoustic source localization of rotor using a novel discrete noise analysis strategy