Abstract:Arrays of well-aligned ZnO nanorods have been grown on Si substrates at 600 degrees C using a catalyst-free pulsed laser deposition (PLD) method, with and Without pre-deposition of a thin ZnO layer at a lower substrate temperature. Deposited products were analyzed and characterized by scanning and transmission electron microscopy (SEM and TEM), energy dispersive X-ray analysis, X-ray diffraction and photoluminescence (PL) measurements. EM revealed that rods grown directly on Si exhibit needle-like morphologies, with diameters, d, typically in the range 20-60 nm, lengths similar to 200-800 nm and, in most cases, capping particles of similar cross-section at their tips. HRTEM images show that these nanoparticles are ZnO also, suggesting that these derive from post-growth crystallisation of oxygen rich molten zinc droplets that cap the nanorods during growth. PLD of ZnO onto Si substrates that have been pre-coated with a thin ZnO film deposited at 300 degrees C yields denser, more uniform arrays of longer (similar to 1-1.2 mu m), thinner (d similar to 6-20 nm) nanorods, without any obvious capping particle. This suggests that a ZnO buffer layer can play a useful role in providing a high density of nucleation sites for subsequent growth of smaller diameter nanorods. The respective product arrays are most readily understood in terms of vapor-liquid-solid (V-L-S) and vapor-solid (V-S) growth models, respectively. Comparative studies of the room temperature PL from the respective samples reveal much higher UV emission intensity from nanorod arrays grown on the ZnO pre-coated Si substrates. (C) 2005 Elsevier Ltd. All rights reserved.

Effects of Growth Time on Morphologies of ZnO Nanorod Arrays

Effect of Electrodeposition Time on Microstructure, Wettability and Optical Properties of ZnO Nanorod Arrays

Effect of UV irradiation on the properties of ZnO nanorod arrays prepared by hydrothermal method

Alignment-controlled Hydrothermal Growth of Well-Aligned ZnO Nanorod Arrays

Growth of diameter-controlled zno nanorod arrays by hydrothermal technique for polymer solar cell application

Hydrothermal Synthesis of Well-Aligned ZnO Nanorod Arrays on Silicon

Low-Temperature Synthesis and Optical Property of ZnO Nanorod Arrays

Hydrothermal Grow th of Vertical and Uniform ZnO Nanorod Arrays and Related Influences

Influence of hydrothermal time on structural properties of ZnO nanorods grown on spin-coated ZnO seeding layer

Electronic Structure and Optical Properties of Vertically Aligned Zno Nanorod Arrays Grown by Low-Temperature Hydrothermal Method

ZnO Nanorod Arrays: Field-assisted Growth in Aqueous Solution and Field Emission Properties

Growth and Interconversion of ZnO Nanostructure Films on Different Substrates

Effect of Substrate Temperature on the Growth and Photoluminescence Properties of Vertically Aligned ZnO Nanostructures

A Simple Route to Controllable Growth of ZnOnanorod Arrays on Conducting Substrates

Growth Mechanisms for ZnO Nanorods Formed by Pulsed Laser Deposition

Growth of flower-like ZnO on ZnO nanorod arrays created on zinc substrate through low-temperature hydrothermal synthesis

Effects of preparing conditions on the electrodeposition of well-aligned ZnO nanorod arrays

Aligned ZnO Nanorod Arrays Fabricated on Si Substrate by Solution Deposition

Growth of Zn thin films based on electric field by thermal evaporation method and effect of oxidation time on physical properties of ZnO nanorods

Size-controllable Growth of ZnO Nanorods on Si Substrate

The Effect of Growth Conditions on the Properties of ZnO Nanorod Dye-Sensitized Solar Cells