Abstract:High dense Al4SiC4–SiC ceramic composites with different SiC contents were hot pressed using self-synthesized Al4SiC4 and commercial SiC powders without any sintering additives. The effect of SiC contents on the densification, microstructure, and mechanical properties of Al4SiC4-based ceramics was investigated. The anisotropic growth of Al4SiC4 grains was inhibited by the pinning effect of the introduced SiC particles, while the weakly bonded interfaces were formed due to the thermal expansion mismatch between Al4SiC4 and SiC. As a consequence, the mechanical properties of Al4SiC4-based ceramics were improved significantly. With the SiC contents increasing from 0 to 30 wt%, the flexural strength increased from 314 ± 7 to 466 ± 18 MPa and the fracture toughness increased from 4.8 ± 0.4 to 7.3 ± 0.3 MPa m1/2, respectively. The flexural strengths of Al4SiC4–SiC composites at elevated temperatures were also tested under an argon atmosphere. No strength degradation of Al4SiC4–SiC composites was observed at 1200 °C and a high strength retention rate of 96.3 % at 1400 °C was obtained. The above results demonstrate the application prospects of Al4SiC4–SiC ceramics as high-temperature structural materials.

The dependence of interlocking and laminated microstructure on toughness and hardness of β-SiC ceramics sintered at low temperature

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Enhanced toughness and hardness at cryogenic temperatures of silicon carbide sintered by SPS

Mechanical properties and microstructure of laminated Si3N4+SiCw/BN+Al2O3 ceramics densified by spark plasma sintering

Processing and mechanical properties of B4C-SiCw ceramics densified by spark plasma sintering

Fabrication, Microstructure, and Properties of SiC/Al 4 SiC 4 Multiphase Ceramics Via an In-Situ Formed Liquid Phase Sintering

Fabrication, microstructure, and properties of SiC/Al4SiC4 multiphase ceramics via an in-situ formed liquid phase sintering

Microstructure, mechanical properties and thermal shock behavior of h-BN-SiC ceramic composites prepared by spark plasma sintering

Microstructure and mechanical properties of spark plasma sintered SiC ceramics aided by B4C

Microstructure and Mechanical Properties of SiC F /sibcn Ceramic Matrix Composites

Effect of temperature on the structure and mechanical properties of SiC–TiB2 composite ceramics by solid-phase spark plasma sintering

Study on the Performance for Silicon Carbide Ceramics by Hot-pressing Sintering

Microstructure and Fracture Behavior of Β-Si3n4 Based Nanoceramics

Microstructure and Mechanical Properties of SiC-GNPS-SiCW Ceramics by Oscillatory Pressure Sintering

Highly dense β-SiC ceramics with submicron grains prepared by sintering of nanocrystalline powders

Investigation of the effect of pressure, sintering temperature and time on silicon carbide microstructure

Effects of SiC contents on the microstructure and mechanical properties of Al4SiC4–SiC ceramic composites

Mechanical Properties and Toughening Mechanisms of Si3n4 Matrix Laminated Ceramic Composite

Microwave Sintering of Si3N4 Ceramics

Pressureless Sintering and High-Temperature Strength of SiC-AlN Ceramics