Abstract:This paper presents a 10.56-GHz transceiver with ultracompact transformer-based transmit/receive (T/R) switching via matching network reuse. The reused transformer can operate as T/R switch and impedance matching networks for a power amplifier (PA) and a low-noise amplifier (LNA) simultaneously. The T/R switch, PA, and LNA are fully codesigned, and the interstage matching networks of the PA and LNA are comatched with the T/R switch to improve the performance of the front end (FE). A three-coil transformer is introduced in the PA to improve the linearity and bandwidth of the FE in the transmit (TX) mode. A mode selection unit (MSU) is also utilized in LNA to improve the TX/RX isolation and the linearity of the FE in the TX mode. Utilizing the fully codesign technique in the FE, the bandwidth of the FE is extended to over 4.2 GHz in both the TX and RX modes. A novel “gm-cell-based” broadband programmable gain amplifier (PGA) and a third-order transconductance-capacitor (gm-c) low-pass filter (LPF) are used in analog baseband to provide over 24-dB gain and 1.8-GHz bandwidth adjustment range with ultralow dc power consumption. To prove the concept, the new architecture is implemented in 28-nm CMOS technology. Measurement results prove that the insertion loss of the proposed T/R switch introduced in both the TX and RX modes is ~0.5 dB, and benefiting from this, the RX obtained a 4.2-dB noise figure, and TX obtained 9.9- and 14.1-dBm OP1dB and Psat. The measured single sideband bandwidth of the transceiver is wider than 2.1 GHz in both the TX and RX modes.

Co-design of 60GHz wideband front-end IC with on-chip Tx/Rx switch based on passive macro-modeling

Co-Design of 60-Ghz Wideband Front-End IC with On-Chip T/R Switch Based on Passive Macro-Modeling

3D Heterogenous Integrated Wideband Switchable Bandpass Filter Bank for Millimeter Wave Applications

A 56 – 65 GHz Highly-Integrated FMCW Radar Transceiver with 7.8 Db NF and 8 GHz Chirp-Bandwidth in 65-Nm CMOS

A 54-67-ghz Low-Power Highly-Integrated Transceiver in 65-Nm CMOS for FMCW Radar Applications

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A G-Band Wideband Bidirectional Transceiver Front-End in 40-Nm CMOS

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A Ka-Band Single-Chip SiGe BiCMOS Phased-Array Transmit/Receive Front-End

An Ultra-Compact W-band Front-End with Coupled-Line-Based Matching Network Reused T/R Switch Achieving 13.4-Dbm Psat and <2-Db Switch Loss in 65-Nm CMOS Technology

A 22 nm CMOS 2.4 GHz 40.91 dB voltage gain RX front-end design

Co-Design of a Low-Noise Amplifier and SPDT SW for Band 42 T/R Modules with Low NF, High Gain, and 50-ohm Matching in Bulk CMOS Technology

Performance evaluation and receiver front-end design for on-chip millimeter-wave wireless interconnect

An Efficient Mm-Wave Integrated Circuit Synthesis Method With Accurate Scalable Passive Component Modeling

The Design of a 57-65Ghz SPDT Switch with LC Resonant Techniques in 40 Nm CMOS Process

Chip-package co-design of common emitter LNA in system-on-package with on-chip versus off-chip passive component analysis

Design of a Fully Integrated Switchable Transistor CMOS LNA for 2.1 / 2.4 GHz Application

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Re-use in 28-Nm CMOS Technology

A 0.12mm2 K/Ka Band RX Front-end in 40-Nm CMOS with Inductor-Less LO Generators

A Highly Integrated C-Band Feedback Resistor Transceiver Front-End Based on Inductive Resonance and Bandwidth Expansion Techniques

Chip-package co-design of a concurrent LNA in system-on-package for multi-band radio applications