Abstract:Compared with the position sensor control, sensorless control avoids a lot of defects caused by the position sensor, at the same time makes the system more stability and stronger anti-interference performance, it has more advantages and meets control field's requirements better in the future, it has gradually become a hotspot in the brushless DC motor control field. The rotor position detection has been a very critical research in the brushless DC motor sensorless control. In this paper, a new type of rotor position detection method is proposed, which is based on the principle and mathematical model of a brushless DC motor after the analysis of advantages and disadvantages of the back EMF principle of zero-detection and the method of the back-EMF superposition, which means a combination of the method of the two rotor position detection, as above. This method neither need a delay of 30° nor require a depth filter, the hardware circuit is also simple and there is no need to compensate for the phase shift. Then, the frequency of the detection signal is three times of fundamental wave frequency in this method and the detection signal is easier to detect when the motor running at low speed, which expand the applicable speed range of the electric motor. This paper analyzes the principle and commutation logic of the rotor position detection method, it come up with a conclusion that the stagnation point of the three BEMF superposition derivative is the commutation points of the stator windings, and it uses the method of the back-EMF zero crossings to determine the current conduction state. The simulation model of the brushless DC motor's control system is established in MATLAB /Simulink it uses speed and current double close loop PI control. The result shows that the method is correct and feasible, it can get the right rotor position signal and control motor commutation correctly, the method can achieve the control of brushless DC motor without position sensor, and it can provide a reference for further research.

A Novel Rotor Position Detection Method for Sensorless Control of Magnetic-Geared Permanent-Magnet Brushless Motor

High-Frequency Signal Injection-Based Sensorless Control for Dual-Armature Flux-Switching Permanent Magnet Machine

A Novel Estimation Method of Sensorless Initial Rotor Position for Surface-mounted PMLSM

A Novel Starting Method of Sensorless BLDC Motors for Electric Vehicles

Position Sensorless Control of Surface-Mounted PMLSM with a Novel Starting Method

Sensorless control of permanent magnet synchronous generator in direct-drive wind power system

An Improved Method to Estimate Initial Rotor Position for Surface-Mounted Permanent Magnet Synchronous Motors

An Improved Rotor Position Estimation Method for PMSM Using Low-Resolution Hall-Effect Sensors

Sensorless control and start-up strategy of permanent magnet synchronous motor

Design of Dual Mode Brushless DC Motor Controller Based on Position Sensor or Sensorless

Rotor Position Estimation Approaches for Sensorless Control of Permanent Magnet Traction Motor in Electric Vehicles: A Review

Rotor position detection based on BEMF zero-crossing detection method with three-EMF force superposition

A Novel Initial Rotor Position Estimation Method for Permanent Magnet Synchronous Motors

Speed Sensorless Control for Permanent Magnet Synchronous Motors Based on Finite Position Set

New Tendency of Rotor Position Detection for Position Sensorless Brushless DC Motor

Sensorless Control Method Of Pmsm Based On Extended Kalman Filter

Sensorless Operation of an Inset PM Bearingless Motor Implemented by the Combination Approach of MRAS and HF Signal Injection

A Novel Start Strategy For Permanent Magnet Synchronous Motor

Direct Rotor Position Detection Method for Sensorless Brushless DC Motors

Sensorless Control Strategy of Novel Axially Magnetized Vernier Permanent-Magnet Machine

Position Sensorless Control Based on Sliding Mode Observer for Multiphase Bearingless Motor with Single Set of Windings