Abstract:Contact engineering on monolayer layer (ML) semiconducting transition metal dichalcogenides (TMDs) is considered the most challenging problem toward using these materials as a transistor channel in future advanced technology nodes. The typically observed strong Fermi-level pinning induced in part by the reaction of the source/drain contact metal and the ML TMD frequently results in a large Schottky barrier height, which limits the electrical performance of ML TMD field-effect transistors (FETs). However, at a microscopic level, little is known about how interface defects or reaction sites impact the electrical performance of ML TMD FETs. In this work, we have performed statistically meaningful electrical measurements on at least 120 FETs combined with careful surface analysis to unveil contact resistance dependence on interface chemistry. In particular, we achieved a low contact resistance for ML MoS2 FETs with ultrahigh-vacuum (UHV, 3 × 10-11 mbar) deposited Ni contacts, ∼500 Ω·μm, which is 5 times lower than the contact resistance achieved when deposited under high-vacuum (HV, 3 × 10-6 mbar) conditions. These electrical results strongly correlate with our surface analysis observations. X-ray photoelectron spectroscopy (XPS) revealed significant bonding species between Ni and MoS2 under UHV conditions compared to that under HV. We also studied the Bi/MoS2 interface under UHV and HV deposition conditions. Different from the case of Ni, we do not observe a difference in contact resistance or interface chemistry between contacts deposited under UHV and HV. Finally, this article also explores the thermal stability and reliability of the two contact metals employed here.

Molybdenum Disulfide Dc Contact Mems Shunt Switch

Laterally Actuated Si-to-Si DC MEMS Switch for Power Switching Applications

Fabrication of A Nanoelectromechanical Switch Using A Suspended Carbon Nanotube

Delamination of MoS2/SiO2 Interfaces under Nanoindentation.

Nanoelectromechanical Switches with Vertically Aligned Carbon Nanotubes

Unraveling the Different Charge Storage Mechanism in T and H Phases of MoS2

Design and Analysis of a Lateral Lateral DC-Contact MEMS RF Switch with High Performance

Dramatic Switching Behavior in Suspended MoS2 Field-Effect Transistors

A 0.2 V Micro-Electromechanical Switch Enabled by a Phase Transition

Intermittent Failure Mechanism and Stabilization of Microscale Electrical Contact

Bipolar Resistive Switching in 2D MoSe2 Grown by Atmospheric Pressure Chemical Vapor Deposition

DC-contact Series Radio-Frequency Micro Electromechanical System Switch with Slanting Beams

Friction and Wear Behaviors of Molybdenum Disulfide Nanosheets under Normal Electric Field

Metal Penetration and Grain Boundary in MoS2 Memristors

Switching Mechanism in Single-Layer Molybdenum Disulfide Transistors: an Insight into Current Flow across Schottky Barriers

Low Contact Resistance on Monolayer MoS2 Field-Effect Transistors Achieved by CMOS-Compatible Metal Contacts

Nonvolatile Resistive Switching in Nanocrystalline Molybdenum Disulfide with Ion-Based Plasticity

Realization of A Series Contact Mems Switch with Sion Dielectric Bridge

Micro‐Electromechanical Switch: A 0.2 V Micro‐Electromechanical Switch Enabled by a Phase Transition (small 14/2018)

Single-crystalline Monolayer and Multilayer Graphene Nano Switches

Toward barrier free contact to molybdenum disulfide using graphene electrodes.