Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

Research for Extraction Method of Mems Devices Macro-Model

Research Status of Macro-Modeling of MEMS Devices for Systems Level Simulations

Macromodel extraction for MEMS devices based on model order reduction

Design Method of Non-standard Structure for MEMS Based on Multi-granularity Macro-modeling

Macro modeling method for electrostatic-drive silicon diaphragm

Modeling and Simulation of Electrostatic Micropump Based on MEMS

Macromodeling of the electrostatically actuated circular plate based on mode superposition method

A New Modeling Method of MEMS System's Noise

Macromodeling Of The Electrostatically Actuated Rectangle Plate Based On Modal Projection

An Efficient Macromodel Extraction Strategy for Packaged MEMS Thermal Wind Sensor Considering Multiphysics

Modeling and Simulation of Micromachined Gyroscope

An efficient macro model for CMOS-MEMS thermal wind speed sensor

Layout Extraction and System-Level Modeling Automatically for MEMS Device

Recent Efforts in Modelling Combined Rate, Size and Thermal Effects on Single Crystal Strength

Macro Model Extraction and Analysis of Electrostatically Suspended Micro-gyroscope

Micromagnetic Modeling Simulations And Applications

MEMS Simulation & Model Establishment

Passive Reduced-Order Macromodeling Algorithm for Microelectromechanical Systems

Systematic Direct Solid Modeling Approach for Surface Micromachined Mems

Recent Advances In Automated System Model Extraction (Sme)

A Flexible Microassembly System For Automated Fabrication Of Mems Sensors