Abstract:Due to the trend to build more vehicle models on a common platform, body development is very often on the critical path in the automotive development process. While the virtual assessment of attributes like crash, structural rigidity or production feasibility is common practice today, it is done less systematically for NVH and durability. They are traditionally only considered close to the availability of prototypes. Performance issues discovered at this stage will lead to additional design cycles which conflicts with the need to further shorten the total development time. The process proposed in this paper results in a better initial design by doing more NVH analysis in the pre-CAD phase and a reduced number of iteration cycles required for NVH and durability engineering by iterating much faster to the final design. Mesh morphing and beam concept analysis make it possible to evaluate and optimize functional performance characteristics based upon predecessor FE models. The “hybrid road noise” and “hybrid road” concept deliver representative body loads for NVH and durability analysis before any testing on physical prototypes can be done. A dedicated section will focus on smart approaches to speed up the optimization without compromising the accuracy of these models. “Wave-based substructuring” is a very promising technique that makes it possible to combine detailed FE models of body panels that need to be redesigned with reduced FE models of invariant panels. For the durability assessment of spot and seam welds, a two-step approach is presented that combines computation speed with accuracy. All these accelerated simulation approaches open new perspectives about variability analysis and design for six-sigma. Finally some practical approaches about multi-attribute optimization are explained.

A study on optimization design of engine-room NVH for a modified vehicle

Optimized Design of Inadequate Stiffness of Radiator Frame inside Engine Room on a Specific Vehicle

Study of NVH performance improvement for a four-cylinder diesel engine body

The Optimization Of Vibration Induced By A V6 Engine Cooling Module

Parameters optimization of interconnected hydro-pneumatic suspension for road comfort and road-friendliness based on genetic algorithm

optimized design of radiator frame based on modified vehicle

Coupled optimization of internal combustion engine radiated noise and interior noise

Experiments on match optimization of underhood cooling module

Optimization of New Energy Vehicle Road Noise Problem Based on Finite Element Analysis Method

Challenges of achieving better NVH performance for Chinese domestic brands

Research on optimization control of vehicle road noise performance

Reducing Body Development Time by Integrating NVH and Durability Analysis from the Start

Modal Analysis and Some Solutions to Front Sub-frame on a Car

Vibration and noise reduction for a 490 diesel engine body

Reliability-based optimization of a novel negative Poisson's ratio door anti-collision beam under side impact

Optimization of Engine Cooling Module Vibration Based on a Genetic Algorithm

Acoustic optimisation design for suspension characteristics based on the method of dynamic subsystem modification

Study on the Influence of Rubber Block Materials on NVH Performance of Vehicle Door

Noise reduction optimization for numerous radiator fans for fuel cell vehicle considering thermal-fluid-acoustic synergy

The Simulation and Optimization Design of Adams-Based Engine Suspension System

Low-Noise Design of Stamping Parts in Diesel Engines