Abstract:This work presents an investigation on the compressive strain capacity of resisting buckling on an X80 steel corroded pipeline subjected to a bending moment using nonlinear finite element analysis (FEA) validated by full-scale tests. The modelling results indicate that the existing strain-based assessment method is not suitable for pipelines with deep corrosion and has certain application limitations. Consequently, a new evaluation method based on far-field strain was developed to predict the buckling failure of corroded pipelines subjected to bending loads. The influence of the corrosion shape type, corrosion size (i.e., depth d, length L, and width w), pipe geometry, and internal pressure on the critical buckling strain capacity and critical buckling moment of the pipeline were studied using parameter sensitivity analysis to verify the proposed strain criteria. The results illustrate that the variation trends between the critical buckling strain and the critical buckling moment with each factor were consistent, indicating that the proposed novel strain-based evaluation method is effective and applicable. In addition, the buckling resistance of a pipeline with rectangular corrosion is relatively weaker than that with a semi-spherical corrosion pit or cylindrical grooved corrosion under the same defect size. Further, the critical compressive strain capacity of a corroded pipeline is primarily affected by the depth and width of the corrosion, whereas the effect of the corrosion length is relatively insignificant. Moreover, the critical length and width of the corrosion defect affecting the bending capacity of resisting buckling were determined as L∕Dt=20 and w∕πD=0.5, respectively.

Compressive strain capacity of cold bend pipes

A study of the ultimate compressive strain of local buckling in strain-based design of pipelines

Application Of Compressive Strain Capacity Models To Multiple Grades Of Pipelines

Modelling lateral pipe-soil interaction on soft clay using large displacement sequential limit analysis

Test evaluation of high strain line pipe material

Analysis of local buckling strain of line pipe

Buckling Response of Offshore Pipelines under Combined Tension and Bending

The application of strain-based design to pipelines and the requirements on pipe materials

Deformation Behavior Prediction Of X80 Steel Line Pipe And Implication On High Strain Pipe Specification

Bending Moment Capacity of Pipes

Bending Capacity of Corroded Pipeline Subjected to Internal Pressure and Axial Loadings

Experimental Investigation And Design Of Concrete-Filled Cold-Formed Thin-Walled Steel Tubes Subject To Bending

Parametric study on the mechanical behavior of submarine pipeline for deepwater S-lay operation

Analysis on Buckling Performance of Submarine Pipelines During Deepwater Pipe-Laying Operation

Investigation of bending deformation of underground pipelines induced by differential ground movements

The Feasibility and Prospect of Strain-Based Design to Pipelines in China

Pipeline Lateral Buckling Triggered by the Residual Curvature with Tri-Linear Axial Pipe-Soil Interaction

A novel strain-based assessment method of compressive buckling of X80 corroded pipelines subjected to bending moment load

Theoretical Study on Upheaval Buckling of Subsea Pipelines with Temperature-Dependent Thermal Properties at Different Carbon Contents

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Mechanical study on overbend segment of submarine pipeline during S-Lay