Abstract:Flow boiling in copper foam fin microchannels (FFMC) has demonstrated better heat transfer performance and flow stability. In this work, systematic experiments are conducted to investigate the effects of structural parameters on flow boiling in five FFMCs with porosities ranging from 0.78 to 0.82 and ratios of fin width to channel width ranging from 0.5 to 2. Five mass fluxes ranging from 68 kg/(m2s) to 408 kg/(m2s) and effective heat fluxes ranging from 2 W/cm2 to 297 W/cm2 are tested. The heat transfer, pressure drop, and flow instability characteristics are analyzed. Generally, the heat transfer in FFMCs follows the “three-zone” model. The heat transfer coefficient first increases with increasing heat flux and then decreases. A “synchronous backflow” phenomenon is observed in FFMCs, which is the direct cause of heat transfer deterioration. Due to the interaction of heat transfer area and the transverse flow resistance through the fins, the heat transfer coefficient increases with decreasing porosity in the low-quality region, while the opposite trend is observed in the high-quality region. The utilization efficiency of the fin area decreases as the fin width increases. An optimal ratio of fin width to channel width exists corresponding to the best heat transfer performance, which equals one in this work. A correlation is developed based on 583 data points considering heat transfer mechanisms in channels and fins. The new correlation predicts the experimental values with a mean absolute percentage error of 9 %, and over 99 % of the data are predicted within a 30 % deviation. A performance evaluation criterion is defined to comprehensively compare the FFMCs, and the FFMC with the porosity of 0.78 demonstrates the best flow boiling performance due to higher heat transfer coefficients and lower pumping powers when the ratio of fin to channel width is equal to one.

Thickness Effect on Pool Boiling Heat Transfer of Trapezoid-Shaped Copper Foam Fins

Effect of copper foam thickness on pool boiling heat transfer of HFE-7100

Experimental investigation on the influence of copper foam characteristics on pool boiling heat transfer

Experimental Study of Pool Boiling Heat Transfer on Horizontal Metallic Foam Surface with Crossing and Single-Directional V-shaped Groove in Saturated Water

Material effect on pool boiling heat transfer of open-celled metal foams with low pore density

Pool Boiling Heat Transfer of R141b on Surfaces Covered Copper Foam with Circular-Shaped Channels

Pool Boiling Heat Transfer of R134a on Single Horizontal Tube Surfaces Sintered with Open-Celled Copper Foam

ICOPE-15-C130 Investigation on Pool Boiling Heat Transfer of Metal Foams with Gradient Pore Densities

EXPERIMENTAL STUDY OF POOL BOILING ON SURFACE OF METAL FOAM WITH OPEN CELLS

An Experimental Study of the Effects of Porosity and Ratio of Fin to Channel Width on Water Flow Boiling in Copper Foam Fin Microchannels

Single-directional and crossing V-shaped groove effect on pool boiling heat transfer of metal foam with high pore density

Experimental study on pool boiling enhancement by unique designing of porous media with a wettability gradient

Influences of Nanoparticles on Pool Boiling Heat Transfer in Porous Metals

Flow Boiling Heat Transfer in Copper Foam Fin Microchannels with Different Fin Widths Using R134a

Heat Transfer Performance of Pool Boiling on Horizontal Surface Sintered with Copper Fiber Felt

Experimental study on pool boiling heat transfer in gradient metal foams

Experimental correlation for pool boiling heat transfer on metallic foam surface and bubble cluster growth behavior on grooved array foam surface

Effect of biomimetic fishbone-patterned copper tubes on pool boiling heat transfer

Experimental Investigation on Pool Boiling Mechanism of Two-Level Gradient Metal Foams in Deionized Water, Aqueous Surfactant Solutions and Polymeric Additive Solutions

Enhanced Boiling Heat Transfer by Gradient Porous Metals in Saturated Pure Water and Surfactant Solutions

Effect of structural characteristics on the natural convective heat transfer performance of copper foam