Abstract:ZnO is a common electron transport layer in organic solar cells that typically requires treatment with an additional layer to passivate surface traps to optimize the device performance. Here, we present a “one-step” approach to modifying ZnO electron transport layers (ETLs) used in organic solar cells. This approach involves adding benzoic acid (BZA) derivatives directly to the ZnO precursor solution, which are then present at the surface of the resulting ZnO film. We demonstrate this approach for three different BZA derivatives, namely, benzoic acid, 4-chlorobenzoic acid, and 4-hydrazinobenzoic acid. For all molecules, improved device performance and stability is demonstrated in solar cells using an active layer blend of PTQ10 (donor) and ITIC-Br (nonfullerene acceptor) compared to such cells prepared using untreated ZnO. Furthermore, similar or improved device performance and stability is demonstrated compared to conventional PEIE treatment of ZnO. The presence of the BZA derivatives at the surface after processing is established using X-ray photoelectron spectroscopy and near-edge X-ray absorption fine-structure spectroscopy. From atomic force microscopy analysis and X-ray diffraction studies, the addition of BZA derivatives appears to restrict ZnO grain growth; however, this does not negatively impact the device performance. ZnO layers treated with BZA derivatives also exhibit a higher water contact angle and lower work function compared to untreated ZnO. Improved device performance is attributed to reduced surface recombination at the ETL/active layer interface, while improved device stability is attributed to the increased hydrophobicity of the ETL. This approach enables simplification of device manufacture while still allowing for optimization of the surface properties of metal oxide ETLs.

H2–CH4 Mixed Gas Plasma Treatment on LP-MOCVD ZnO:B for Amorphous Silicon Thin Film Solar Cells

Investigation in Feasibility of Molybdenum As A Back Contact Layer for Silicon Based Quantum Dot Solar Cells

Enhanced photocatalytic activity of Mg 0.05 Zn 0.95 O thin films prepared by sol–gel method through a cycle

Trade-offs of the opto-electrical properties of a-Si:H solar cells based on MOCVD BZO films.

Study of Boron-Doped Zinc Oxide Film Serving As Front Contact with High Haze Used in Amorphous Silicon Thin Film Solar Cells

Combined SiO2 Antireflective Coatings with MOCVD-ZnO:B to Improve Light Absorption in Thin-Film Solar Cells

Development of textured ZnO-coated low-cost glass substrate with very high haze ratio for silicon-based thin film solar cells

Modified Textured Surface Mocvd-Zno:B Transparent Conductive Layers for Thin-Film Solar Cells

Low Oxygen Content MoOx and SiOx Tunnel Layer Based Heterocontacts for Efficient and Stable Crystalline Silicon Solar Cells Approaching 22% Efficiency

Tailoring the Morphology, Optical and Electrical Properties of DC-sputtered ZnO:Al Films by Post Thermal and Plasma Treatments

Comprehensive Study of Sf6/O-2 Plasma Etching for Mc-Silicon Solar Cells

Exploring co-sputtering of ZnO:Al and SiO2 for efficient electron-selective contacts on silicon solar cells

Application of Textured ZGO Films on Amorphous Silicon Based Solar Cells

Textured surface boron-doped ZnO transparent conductive oxides on polyethylene terephthalate substrates for Si-based thin film solar cells

Morphology Evolution of the Light Trapping Structure Using Atmospheric Plasma Textured C-Si Wafer for Silicon Solar Cells

Texture surfaces and etching mechanism of ZnO:Al films by a neutral agent for solar cells

One-Step Preparation of ZnO Electron Transport Layers Functionalized with Benzoic Acid Derivatives

Light Scattering by Textured Al-Doped Zinc Oxide Film for Thin Film Silicon Solar Cells Coated on Glass Substrates

Anisotropic etching behavior and topography formation mechanism of silicon solar cell surface textured by atmospheric plasma

Liquid-phase-deposited silicon oxide film as a mask for single-sided texturing of monocrystalline Si wafers