Abstract:The stress response behaviors of steel wires at the anchorage part of bridge cables under tension and bending coupling loads play a predominant role in determining their fatigue life and failure modes. The inherent complexity of the spiral geometry and the large diameter of actual bridge cables made the stress response behaviors of steel wires at the anchorage part unclear up to now. An analytical method was proposed for spiral steel wires at the anchorage part of semiparallel steel wire cables under tension and bending coupling loads. The corresponding refined numerical modeling method was also developed for studying the local anchorage part. Both the analytical formulation and numerical model agree well with the related experimental results in the literature. The presented analytical and numerical methods are thereby efficient and accurate to simulate bridge cables under tension and bending coupling loads. The critical slip curvature of steel wires increases linearly with the tensile strain of the bridge cable. The axial stresses of the steel wires of the bridge cable at a given longitudinal location display a linear relation with the angular change at the anchorage end. For steel wires located at the guide deviator part of the bridge cable, the axial stress behavior differs between the stick and slip states. It changes to a chord curve in the longitudinal direction in the stick state, while it follows an exponential function with respect to the polar angle in the slip state. The axial stress range of the outermost steel wire of the bridge cable increases linearly with the harmonic tension load range and the bending load range, separately. Regarding the phase difference between harmonic tension and bending coupling loads, a phase difference of 0 represents the most unfavorable combination for the bridge cable. By contrast, when the phase difference falls between 0 and π/2, the two harmonic loads tend to mutually inhibit each other’s effects on the cable’s behavior.

The Study on Stress-Cone Based on HTS Cable Terminal

Research on Structure Optimization of Cold Dielectric High-Temperature Superconducting Cables

Tuning the Potential Distribution of Ac Cable Terminals by Stress Cone of Nonlinear Conductivity Material

Electric field calculation and optimization for stress cone of DC cable joint based on the coaxial double-layer insulation model

Experimental Study on Stress Relaxation Properties of Structural Cables

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Investigation on Loss Reduction Strategies of Single-Core HVAC Submarine Cables

Mechanical Properties of Concentric Three-Phase HTS Cable Based on Laminated Theory

Electric-Thermal Field Analysis for EPR On-Board Cable Terminal Using Stress Tube Modified by ZnO Nonlinear Material

Simulation Analysis of 35kv AC PP Insulated Cable Terminal Accessory

Numerical Analysis on the Current Distribution and the Loss in HTS Stacked Tapes Considering Termination Resistances

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

Material Properties and Electric–Thermal–Stress Multiple Fields Coupling Simulation of Power Distribution Cable Accessories

Structural Design and Mechanical Analysis of HTS CICC Made From Twisted Stack Slotted-Core Cable

Stress Response Behaviors of Steel Wires at the Anchorage Part of Bridge Cables under Tension and Bending Coupling Loads

Study on Performance Degradation of Multi-Layer Spiral Superconducting Cable Under Bending Load

Measurement Method of Stress in High-Voltage Cable Accessories Based on Ultrasonic Longitudinal Wave Attenuation

Towards Electrothermal Optimization of a HVDC Cable Joint Based on Field Simulation

Numerical Simulation of the Dynamic Responses of Electric Power Fitting of Transmission Lines after Ice Shedding

Electric field distribution and performance optimization of high-speed train cable terminal with internal defects

Research on overcurrent stability of HTS cable for energy pipeline