Abstract:Surface charge accumulation on insulating materials is a major factor that distorts the electrical field and thus reduces the insulation level. Therefore, the phenomenon of surface charge accumulation has drawn more and more attention. In this paper, the relationship between the surface charge density distribution and the output voltage of electrostatic probe was discussed, and an improved algorithm was built to calculate the charge density and electrical field distribution from the output voltage. Two-dimensional Discrete Fourier Transformation (2D-DFT) was used to reduce the amount of calculation by transferring the convolution in spatial domain to multiplication in spatial frequency domain. The algorithm considered the influence of electrostatic probe, and the Wiener filter was employed to reduce the noise. The influence of the meshed size on noise suppression and algorithm's accuracy was studied, and the spatial resolution of this measurement system including the reverse calculation process and the accuracy of algorithm was investigated. The charge density distribution as well as the field distribution was calculated by this improved algorithm, when a lightning impulse voltage was applied to a PMMA plate. The results show that the surface charge density and electric field distribution calculated by this algorithm have a good resolution. The spatial resolution of this measurement system with 1mm gap between the electrostatic probe and the surface of the insulation is 0.3341mm, and the peak-mean square error is only 0.23％. Reduce the size of the meshed unit caneffectively suppress the noise and increase the algorithm's accuracy. The improved reverse algorithm has great resolution and accuracy, and can exactly calculate the surface accumulating charge density and electrical field distribution of insulating materials.

Inverse Calculation of Surface Charge Based on Surface Potential Measurement

Inversion Algorithm to Calculate Charge Density on Solid Dielectric Surface Based on Surface Potential Measurement

Measurements and Calculations of Surface Charge on the Cone-Type Insulator

Surface Charge Inversion Algorithm Based on Bilateral Surface Potential Measurements of Cone-Type Spacer

Surface Charge Measurement under AC Voltage Using Active Electrostatic Probe and Controllable Phase Truncation Scheme

Improved Reverse Algorithm of Surface Charge Density Distribution and Electric Field Distribution Based on Electrostatic Probe

Charge Inversion Algorithm in Surface Charge Measurement Based on Pockels Effect

Measurement Method and Accumulation Characteristics of Surface Charge Distribution on Polymeric Material under DC Voltage

Improved Algorithm of Surface Charge Density Distribution and Electric Field Distribution on Insulating Materials

A Simplified Method to Estimate Surface Trap Distribution: Potential Decay by Charge Dissipation Along Surface

Review and Prospect of Surface ChargeInversion Algorithm of Cone-Type Spacer Based on Surface Potential Measurements

Surface Charge Distribution on DC Basin-Type Insulator

Surface charge inversion algorithms based on integral equation method

Monte Carlo Study on the Surface Potential Measurement Using the Peak-Shift Method

Surface Charge Distribution of DC GIL Basin-type Insulator

Calibration algorithm of surface charge density on insulating materials measured by pockels technique

From Surface Potential to Surface Charge: An Inversion Algorithm for Shift-Variant System Based on Hybrid LBD-Tikhonov Method

Surface Charge Accumulation Phenomenon at the Gas-solid Interface Under DC Voltage

Surface Charge Accumulation Behavior On Gil Spacer Under Dc Voltages In Sf6/N-2 Mixtures

Analysis of Surface Charge Decay Process on Insulators in SF6 and Air

Research on Calculation and Characteristics of Surface Charge on Epoxy Composite Insulation under Dc Voltage