Abstract:Charge accumulation on a solid insulator surface is one of the critical factors for the development of dc gas-insulated equipment since it will lead to the overstress of polymeric insulation due to local field distortion and enhancement. Therefore, it is important to study the charge accumulation phenomenon on spacer surface under dc field. For decades, researchers have made tremendous progress on this subject by measurement and simulation. However, measurement results are quite different by different researchers due to various electrode configurations and experimental conditions. Further, most researchers use potential to represent charge density, which is not rigorous in that many charge density distribution details are hidden behind the potential. As for pure numerical simulation, reports are rather academic and sometimes cannot accord with the real fact. In this paper, attempts are made to characterize the charge accumulation patterns on spacer surface in HVDC gas-insulated system. Surface charge distributions on a model GIL spacer in 0.1 MPa air under DC voltage are obtained by an advanced measurement method, from which the dominant uniform charging pattern and random charge speckles are separated. Mechanism responsible for the dominant uniform charging pattern is discussed with the aid of a simulation model. Results indicate that, in a well-cleaned system, the electric current through the spacer bulk is the principal factor, but gas conduction is not negligible due to some inevitable ion sources. Highly localized pockets of charge are also observed, which are referred to as speckles. They may originate from micro discharges due to tiny metal particles on the spacer surface or microscopic protrusions on the electrodes.

A Simplified Method to Estimate Surface Trap Distribution: Potential Decay by Charge Dissipation Along Surface

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Correlation of Traps Inside XLPE and Polypropylene with Space Charge Dynamics under Polarity Reversal Condition

Measurement Method and Accumulation Characteristics of Surface Charge Distribution on Polymeric Material under DC Voltage

Study on the Effect of Metal Particles on the Surface Trap Characteristics of Different Insulating Materials

Measurements and Calculations of Surface Charge on the Cone-Type Insulator

Inverse Calculation of Surface Charge Based on Surface Potential Measurement

Surface Charge Measurement under AC Voltage Using Active Electrostatic Probe and Controllable Phase Truncation Scheme

Inversion Algorithm to Calculate Charge Density on Solid Dielectric Surface Based on Surface Potential Measurement

Visualization of surface discharge area in SF6 based on infrared trap

Analysis of Surface Charge Decay Process on Insulators in SF6 and Air

Charge Accumulation Patterns on Spacer Surface in HVDC Gas-Insulated System: Dominant Uniform Charging and Random Charge Speckles

Review of Surface Charge Accumulation on Insulators in DC Gas-Insulated Power Transmission Lines: Measurement and Suppression Measures

Surface charging physics of the basin insulator in ±320 kV gas-insulated transmission lines

Accumulation Characteristics of Surface Charge on a Cone-type Model Insulator under DC Voltage

A method for measuring surface electric field intensity of insulators based on electroluminescent effect

A Simple Method to Measure DC Electric Field with Space Charges

Surface Charge Accumulation Phenomenon at the Gas-solid Interface Under DC Voltage

Design of capacitive electrostatic probes for online measurement of surface charge on ±320 kV tri‐post insulators

X-Ray Radiation As a Possible Approach for Realizing Surface Charge Decay on Post Insulators Inside SF6

Interpretation of the Surface Charge Decay Kinetics on Insulators with Different Neutralization Mechanisms